Maintenance; General Instructions - Chicco Simplicity Bedienungsanleitung

the safest way.
• This product must only be used by
an adult.
• The product must be assembled by
an adult.
• To avoid all strangulation risks, nev-
er give children objects with cords
or strings attached, or leave them
with in proximity of such objects.
• Never use the stroller on staircases
or escalators: you could suddenly
lose control of it.
• Always pay attention when going
up and down steps or pavements.
• If the stroller has been exposed di-
rectly to sunlight for a long time,
you must let it cool down be-
fore placing your child inside of it.
Prolonged exposure to direct sun-
light may cause the colour of the
materials and fabric to fade.
• Prevent the stroller from contact
with salty water. It might cause the
formation of rust.
• Do not use the stroller on the
beach.
• When unused, the stroller should
be kept out of reach of children.
TIPS FOR CLEANING AND MAINTENANCE
This product requires periodical maintenance. Cleaning and
maintenance operations must be performed exclusively by
an adult.
CLEANING
The lining can be removed (please see the section FITTING
AND REMOVING THE STROLLER LINING). Clean the fabric
parts using a wet sponge and neutral soap. Periodically
wipe clean plastic parts with a soft damp cloth. In case the
stroller has come into contact with water, always dry the
metal parts to prevent rust formation Below are the clean-
ing symbols and their meanings:
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean

MAINTENANCE

Lubricate the moving parts only if necessary, with a light
application of a silicone based lubricant. Regularly check
the condition of the wheels and, keep them clean of dust
and sand. To avoid friction that may prevent correct opera-
tion of the stroller, make sure that all the movable plastic
parts along the metal frame are clean of dust, dirt or sand.
Keep the stroller in a dry place.

GENERAL INSTRUCTIONS

HOW TO OPEN THE STROLLER
WARNING: When opening the stroller, make sure that your
child or other children are at a safety distance. Make sure
that during these operations the moving parts of the stroll-
er will not come into contact with your child
1. Press the buttons on the sides and lift the handlebar at the
same time as shown in figure 1A. Then push switch A to the
left and press button B at the same, as shown in figure 1B.
Pull the handle up to open the stroller until you hear a click
confirming locking (fig. 1C).
WARNING: before use, make sure that the stroller is locked
in open position, checking that the mechanism is actually
locked.
HOW TO ASSEMBLE THE FRONT WHEELS
2. Fit the front wheels on the stroller until they are locked
in position (fig. 2). Repeat this procedure for the other
wheel lock.
WARNING: Before use, ensure that the wheels are correctly
locked into position.
ASSEMBLING THE REAR WHEELS
3. Parts needed to fit the rear wheels: see fig. 3.
4. To assemble the wheels on the rear axle (E), fit the follow-
ing parts in the correct order (see fig. 4A):
• wheel (A)
• washer (B)
• spring pin (C)
• wheel cover (D)
Make sure you insert the fastening spring pin as indicated
in the diagram: the straight side is to be inserted through
the hole in the axle (fig. 4B). Repeat the operation for the
other rear wheel following the same order.
5. Fit the rear axle into relevant slots in the frame until you
hear it click into place (fig. 5).
WARNING: always check the rear axle is fitted properly be-
fore using the stroller.
CARRY-ALL BASKET
6. Fit the basket support tube in the rear part of the stroller
as shown in figure 6 until you hear it click into place.
7. Complete the assembly operations in the front part of
the basket passing the ribbons through the relevant
holes in the fabric and on the support tube located un-
12
AD
8. T
s
d
BU
9. T
l
i
10
11
WA
the
HO
Th
sh
cro
12
WA
ne
us
WA
ing
thr
ma
ch
pu
HO
Th
13
14
WA
mo
RE
Th
sim
alo
15
16
SW
17