List Of Components; Maintenance - Chicco Best Friend PRO Gebrauchsanleitung

product and its components have
not been damaged during transpor-
tation. In this case, do not use and
keep out of reach of children.
• Do not use this product if any part
is broken, torn or missing.
• The product must only be assembled
by an adult.
• This product must only be used by
an adult.
• Make sure that the person using the
stroller knows how to operate it in
the safest way.
• Ensure that during these operations
the moveable parts of the stroller do
not come into contact with your child.
• Never use the stroller on staircases or
escalators: you could suddenly lose
control of it.
• Always pay attention when going
up and down steps or pavements.
• Do not let your child climb onto the
storage basket; it could break the
basket, injure the child and overturn
the stroller.
• To avoid all strangulation hazards,
never give children objects with
cords or strings attached, or leave
them close to such objects.
• If the stroller is left exposed to direct
sunlight for an extended period of
time, allow it to cool down before
placing your child inside.
• Prolonged exposure to direct sun-
light may cause the material and
fabric to fade.
• Prevent the stroller from coming into
contact with salt water. It may cause
rusting.
• Do not use the stroller on the beach.
• When not in use, the stroller should
be kept out of reach of children.

LIST OF COMPONENTS

• Frame
• Seat
• 2 Rear wheels
• 2 front wheels
• Bumper bar
• Storage basket
• Canopy
• 2 shoulder strap pads and one crotch strap cover pad
(comfort kit)
• Rain cover
Important Note: The pictures and instructions contained
in the booklet refer to the complete stroller model. Some
of the components and functions described here may vary
depending on the model purchased.
ADVICE FOR CLEANING AND MAINTENANCE
This product requires periodical maintenance. The cleaning
and maintenance of the product must only be carried out
by an adult.
CLEANING
The cover cannot be removed. Clean the fabric parts using a
wet terry towel and neutral soap. Periodically wipe the plastic
parts clean with a soft damp cloth. After possible contact
with water, dry the metal parts in order to avoid the forma-
tion of rust. Do not use solvents or abrasive products. The
washing symbols and relative meanings are indicated below:
Do not wash
Do not bleach
30° C
Do not tumble dry
Do not iron
Do not dry clean

MAINTENANCE

If necessary, lubricate the moving parts with dry silicone
lubricant. Regularly check the condition of the wheels
and clean off all dust and sand. To avoid friction that may
compromise the correct functioning of the stroller, make
sure that all plastic parts that slide on the metal tubes are
free of dust, dirt and sand. Keep the stroller in a dry place.
FIRST ASSEMBLY OF THE STROLLER
1. Release the closing device (Fig. 1) and push the front
part of the stroller forward until you hear a click (Fig. 1A).
2. Insert the front wheel into the appropriate hole until hearing
a locking click (Fig. 2). Repeat the same operation for the
second front wheel.
3. To mount the rear wheel, insert the wheel pin into the
hole on the rear leg tube, ensuring that the flat part of the
pin corresponds with the hole in the frame as shown in
Figure 3. Repeat the same operation for the other wheel.
WARNING: Before using the stroller, make sure that the
wheels are well secured to the structure.
4. Install the basket, positioning the part with the strips in
the direction of the front tube. Insert the strips into the
designated holes on the frame, fastening them with the
specific snap buttons (Fig. 4).
Fasten the basket to the central part of the rear tube by
securing it to the two sides with the two snap buttons (A)
14