Cleaning And Maintenance - Chicco Living Smart Gebrauchsanleitung

CLEANING AND MAINTENANCE

The cleaning and maintenance of this product must be carried
out on a regular basis by the user. The cleaning and mainte-
nance of the stroller must only be carried out by an adult.
CLEANING
The cover can be removed (please refer to the section "re-
movable cover").
clean the fabric parts.
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
Use a soft cloth to clean the plastic parts on a regular basis;
metal parts to prevent the formation of rust if the stroller
MAINTENANCE
clean of dust and sand. Make sure all plastic parts that slide
along the metal tubes are clean and free from dust, dirt and
OPENING INSTRUCTIONS
and all other children are at a safe distance. Ensure that
during these operations the moving parts of the stroller do
1. Before opening the stroller, press the side button (diagram
1A) to raise both handgrips into the right position. Make
sure that the handgrips are locked in the UP position, as
seen in diagram 1 B.
2. Pull both the small levers on the stroller handles at the
3. Raise the stroller to make it easier for it to open (dia-
gram 3).
completely and locks the stroller in the open position (dia-
gram 4)
position, checking that the rear cross bar is locked in place.
FITTING/REMOVING THE LINING
For practical reasons, this operation should be performed
5. Start by fitting the top part of the fabric (diagram 5A) so
that it fits neatly over the back, as seen in diagram 5B. Align
buttons near the rings seen in diagram 5 D, then fasten the
fasteners (B) found on the side of the structure as indicated
in diagram 5 E. Fit the leg rest supports into the fabric as
seen in diagram 5 F.
6. Slide the "D" rings through the slots (diagram 6)
7. Thread the lap belt into the "D" rings as seen in diagram 7.
port and held in place by the structure. The crotch strap
must be threaded through the slot in the lining to ensure
correct and safe use, as seen in diagram 8. Please refer to
use the harness correctly
buttons found inside the armrests
(diag. 9).
SAFETY HARNESS
mately 6 months of age, it is necessary to use the shoulder
10. Slide the safety clasps into the fabric slots (diagram
10A) and check that the shoulder straps are fitted at the
right height for the child: if this is not the case, adjust the
height (diagram 10).
11. Place the child inside the seat, slot the 2 toothed ends
the clasps (diagram 11).
gether at the same time (diagram 12).
6684 Standards. The rings are positioned inside the seat
guarantee complete safety for your child.
both the crotch strap and the safety harness.
using the anchorage points. The harness must be re adjusted.
To ensure that the harness is adjusted correctly, fitting your
child and securely closed, pull firmly on the end of the harness
(on the underside of the seat).
FITTING THE SEAT IN THE PARENT -FACING POSITION
seat in this position.
13. To fit the seat in the parent-facing position, open the
(diagram 13 A) slide it onto the hooks (diagram 13 B and
C) found on the stroller structure as seen in diagram 13 D.
into place (fig 14).
ment devices are correctly engaged before use.
using the anchorage points. The harness must be re adjusted.
To ensure that the harness is adjusted correctly, fitting your
child and securely closed, pull firmly on the end of the harness
(on the underside of the seat).
FITTING THE SEAT IN THE FRONT- FACING POSITION
15. To fit the seat in the front-facing position, open the seat
15 A) slide it onto the hooks (diagram 15 B and C) found on
the stroller structure as seen in diagram 15 D.
and lock into place (fig 16B).
ment devices are correctly engaged before use.
-
23
-
-
-
-