Maintenance - Chicco CHEERIO Gebrauchsanleitung

lose control of it.
• Always pay attention when going
up and down steps or pavements.
• If the stroller is left exposed to di-
rect sunlight for an extended pe-
riod of time, allow it to cool down
before placing your child inside.
Prolonged exposure to direct sun-
light may cause the colour of the
materials and fabric to fade.
• Prevent the stroller from coming
into contact with salt water. It may
cause rusting.
• Do not use the stroller on the
beach.
• When not in use, the stroller should
be kept out of reach of children.
TIPS FOR CLEANING AND MAINTENANCE
This product requires periodical maintenance. Cleaning and main-
tenance should only be carried out by an adult.
CLEANING
The seat of the stroller can be removed (please see the section FIT-
TING AND REMOVING THE STROLLER LINING). Clean the fabric parts
using a wet terrycloth and neutral soap. Periodically wipe the plastic
parts clean with a soft damp cloth. To prevent the formation of rust,
always dry metal parts if they have come into contact with water.
The washing symbols and relative meanings are indicated below:
Hand wash
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean

MAINTENANCE

If necessary, lubricate the moving parts with dry silicone lubricant.
Regularly check the condition of the wheels and clean off all dust
and sand. To avoid friction that may compromise the correct func-
tioning of the stroller, make sure all plastic parts that run along the
metal tubes are clean of dust, dirt and sand.
Keep the stroller in a dry place.
GENERAL INSTRUCTIONS
OPENING THE STROLLER AND FIRST ASSEMBLY
WARNING: When opening the stroller, make sure that your child or
other children are at a safety distance.
WARNING: Make sure that during these operations the moving
parts of the stroller do not come into contact with your child.
1. Grip the handle (Fig. 1) and pull upwards (Fig. 1A) until the struc-
ture opens fully (Fig. 1B). In the event that the bumper bar has
been mounted on the stroller, after opening the frame reposition
the bumper bar by rotating it forward until it locks in place (Fig.
1C-1D).
WARNING: Before use, ensure that the stroller is locked in the open
position, checking that the mechanism is effectively locked.
2. Assemble the rear wheels by inserting the pin of the wheel into the
appropriate hole located on the rear tube, until it locks in place (Fig.
2). To remove them, use the button located on each wheel (Fig. 2A).
WARNING: Before use, ensure that the wheels have locked correctly.
3. Install the bumper bar (if it hasn't been mounted already) by in-
serting it into the appropriate slots located on the joints of the
stroller (Fig. 3). Should you need to remove it, press the buttons
on both sides (Fig. 3A).
WARNING: Never use the bumper bar to lift the stroller up with
your child sitting in it.
CARRY-ALL BASKET
The storage basket is already installed. Should you need to remove
it, follow the steps outlined below.
4. The storage basket is attached to the frame at several points.
Unsnap the 2 buttons located on the rear of the basket (Fig. 4);
remove the lateral straps on the rear legs of the stroller (Fig. 4A);
unsnap the buttons present under the seat (Fig. 4B); open the vel-
cro straps on the front under the footrest (Fig. 4C).
To reassemble the basket follow the same steps backwards.
HOW TO USE THE SAFETY HARNESS
This stroller has a five-point safety harness featuring two shoulder
straps, two adjustment holes, a waist strap and a crotch strap with
buckle.
5. WARNING: To use it with children from birth to approx. 6 months
of age, you must use the shoulder straps, first threading them
through two adjusting holes (Fig. 5), and threading the waist strap
through the vertical holes (Fig. 5A).
6. After laying the child in the stroller, fasten the straps (Fig. 6) by
passing first the two forks (A) inside the shoulder strap buckle (B)
and then inside the crotch strap buckle (C); adjust the height of
the shoulder straps so that they correctly fit your child's shoulders
(Fig. 6A).
Always make sure that the straps are fastened correctly. To unfasten
the strap, press and pull the side clips (A).
WARNING: To guarantee the safety of your child, the safety harness
must be fastened at all times.
To make sure that the belts are fastened properly to the anchoring
points, after placing your child inside the stroller, pull the end parts
of the belts firmly.
ADJUSTING THE BACKREST
The backrest can be adjusted to several positions.
7. To recline the backrest, use the strap located on the rear; press
on both sides of the clip and adjust the inclination to reach the
desired position (Fig. 7). To lift the backrest press on the clips and
pull down on the strap (Fig. 7A).
WARNING: The child's weight can make these operations more
difficult.
REAR BRAKES
The rear wheels have linked brakes, which can be applied simulta-
neously on both rear wheels by using the support tube.
8. To activate the brakes, press down on the pedal located centrally
(Fig. 8). To release the brakes, press the pedal in the opposite direc-
tion (Fig. 8A).
SUN CANOPY
The canopy is already installed on the stroller.
9. To open and adjust the canopy use the front arch (Fig. 9). The
canopy is equipped with a retractable sunshade.
FITTING AND REMOVING THE STROLLER LINING
To remove the lining from the seat, follow the steps below:
10. Detach all the velcro fasteners and snap buttons that connect
the backrest to the hood (Fig. 10) and remove the straps on both
sides from the plastic hooks that attach the backrest to the han-
dle of the frame (Fig. 10A).
11. On the sides of the seat, remove the velcro fasteners (Fig. 11)
11