SPORTSTECH ES400 Benutzerhandbuch Seite 34

Step 3 ATTACH THE FRONT POST
• Remove the pre-assembled 4 Allen head bolts (38) and 2 plastic washer (37) ,2
curve washers (11) and 4 flat washer (12) 2 spring washer (12) from the main
frame (26).
• Connect the middle section sensor wire (44) of the front post (45) with the lower
section sensor wire (41) securely.
• Connect the tension cable (40) with lower tension cable (43). (See figure).
• Put the front post (45) and front cover (42) into the bottom post of main frame (26)
and fasten with 4 Allen head bolts (38) and 4 plastic washer (37), 4 curve washers
(11), 4 spring washer (12). Please note don't tighten all head bolts (38) too much
at the beginning. When all parts are fixed already, and then fasten each one piece
tightly.
• Assemble bottle holder (45) with 2 screw (6).
• Assemble each pedal (1R&1L) to the crank . Pedal "R" assemble with crank right
side, Pedal "L" assemble with crank left side: See the mark „R" & „L" (right and left)
on the pedals (11R&11L) and crank.
i
NOTE: The right pedal „R" should be threaded on clockwise. The left pedal „L"
should be threaded on counter-clockwise.
• Attach the pedal straps to the pedals (1R&1L).
i
NOTE: Adjust the pedal straps to meet your foot/shoes size by 4 adjustable holes.
34