Cleaning With The Interdental Brush - Nevadent NSZB 3.7 B3 Bedienungsanleitung

6) Start in one quadrant:
Start with the brush head 1 on your gums, and move the brush upwards/
downwards from the gums to the crown of the tooth .
Continue in this manner on both the inside and the outside of the tooth .
Start again at the gums for each individual tooth .
Do not forget to brush the back of the rear molars .
To clean the chewing surfaces, guide the brush over them with a little
pressure .
7) After 30 seconds, the toothbrush stops briefly to signal that you should
start cleaning the next quadrant . Clean each jaw quadrant using the same
technique .
8) After two minutes, the toothbrush stops briefly 2 times . This informs you
that you have complied with the dental recommendation of two minutes
cleaning .
9) Press the on/off switch 0 repeatedly until the toothbrush stops .
10) Then take the toothbrush out of your mouth .
11) After use, rinse the brush head 1 thoroughly under running water .
12) Remove the brush head 1 from the handset .
To clean the drive shaft 2 and the handset, hold them under running wa-
ter for a short while . Hold the handset so that the drive shaft 2 is pointing
downwards at an angle .
NOTE
Massage your gums regularly . This promotes blood circulation and helps to
keep them healthy . Set the mode to "Pulse" and guide the moistened brush
over your gums with a light pressure .

Cleaning with the interdental brush

You can use the interdental brush r to clean the interdental spaces, difficult-
to-access parts on the teeth, or the chewing surfaces of your molars .
1) Attach the interdental brush r to the hand element .
2) Moisten the interdental brush r under running water .
3) Put a little toothpaste onto the wet interdental brush r .
NOTE
To avoid splashes, do not switch on the appliance until it is in your mouth .
4) Use the On/Off switch 0 to select the desired operating mode and clean
the required area .
5) Press the On/Off switch 0 repeatedly until the appliance stops .
6) Then take the interdental brush r out of your mouth .
7) After use, clean the interdental brush r thoroughly under running water .
8) Remove the interdental brush r from the hand element .
To clean the drive shaft 2 and the handset, hold them under running water
for a short while . Hold the handset so that the drive shaft 2 is pointing
downwards at an angle .
NOTE
The interdental brush r is ideal for cleaning braces or false teeth .
│ GB │ MT
■ 42 NSZB 3.7 B3