Beko CEG5331X Bedienungsanleitung Seite 35

6
Troubleshooting
Problem
No milk foam out from the
machine
The hole of Milk tube connector
is blocked by milk residues
which hardly to be cleaned
The milk froth is of poor quality
Milk spray out the table
Descaling indicator
flashing even after
descaling process
Fully Automatic Coffee Machine / User Manual
Cause
The hole of Milk tube connector
is blocked by milk residues
The milk tube connector not be
cleaned for a long time
The type of milk used is not
suitable for frothing
The temperature of the milk is
too high
Milk dispensing tube is not put
in place
keep Decaling process
the completed
Solution
Refer to section "Daily Cleaning
of the appliance" ,follow
"cleaning the milk container
and connection milk tube",
Clean the connector and
make sure all the hole on the
connector is clean, use needle
or bristle of brush to clean the
hole.
Soaking the connection milk
tube into warm water for an
hour, follow the "cleaning the
milk container and connection
milk tube" in section "Daily
Cleaning of the appliance",
keep using frothing milk
function
water come from dispenser
smoothly. Use needle or bristle
of brush to clean the hole
Different types of milk result in
different amounts of froth and
different forth qualities. Semi-
skimmed or full-fat cow's milk
gives good results.
No milk foam out from the
machine
Milk foam spray out from
dispenser
is not Please be patient and wait
for the process finish. The
machine will auto shut off
automatically , don't switch off
the machine manually
to clean until
35 / EN