Safety Advice Applicable Specifically To Multi-Purpose Precision Rotary Tools; Charging The Battery Pack - Parkside PFBS 9,6 V Bedienungs- Und Sicherheitshinweise

General safety advice / operation
WArnIng!
d)
rechargeable battery units if they are
misused. If this happens, avoid contact
with the fluid. If contact occurs, flush
the affected area with water. Seek
additional medical help if any of the
fluid gets into your eyes. Escaping bat-
tery fluid may cause skin irritation or burns.
Safety advice applicable
specifically to multi-purpose
precision rotary tools
J
When you use the drill / grinder wear
the following protective equipment:
safety glasses and protective gloves.
CAUtIon! The tool continues to rotate after it
has been switched off! Avoid contact
with rapidly rotating drill / grinder
components.
J
WArnIng!
piece. Use clamps or a vice to grip the workpiece
firmly. This is much safer than holding it in your
hand.
J
WArnIng!
placing your hands near or in front of the device
or the workpiece surface. A slip can result in
injury.
J
DAngEr oF FIrE FroM FLyIng
SPArKS! Abrading metal creates
flying sparks. For this reason, always
make sure that nobody is placed in any danger
and that there are no inflammable materials
near the working area.
J
WArnIng!
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
J
WArnIng!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
30 GB/MT
Fluids may leak out of
Securely support the work-
Never support yourself by
DUSt HAzArD! Any
noXIoUS FUMES!
J
Do not soak the materials or the surface you
are about to work on with liquids containing
solvents.
J
Avoid abrading paints containing lead or other
substances hazardous to health.
J
Do not machine materials containing asbestos.
Asbestos is a known carcinogen.
J
Avoid contact with moving sanding or grinding
tools.
J
Do not machine moist materials or damp sur-
faces,
notE! Do not allow the tool to come to a
standstill by overloading it!
J
WArnIng!
allow it to come to a standstill before you put it
down.
J
WArnIng!
clean, dry and free of oil or grease.
operation
Q
Never use the device for a purpose for which it was
not intended or with non-original parts / accessories.
The use of tools or accessories other than those rec-
ommended in the operating instructions could lead
to you suffering an injury.

Charging the battery pack

Q
notE! A battery pack that has been
unused for a while or never been charged
must be charged before reuse or first use.
The battery pack requires about 3-5 cycles before
it can reach its full charge.
CAUtIon! Always pull out the mains plug
(mains adapter ) before you insert the bat-
9
tery pack into or take it out of the charger.
j
Connect the adapter
j
Insert the battery pack
cradle . This can only be inserted with the
8
correct polarity.
j
The LED lights up green whenever the bat-
10
tery pack is in the charging cradle
3
the adapter is connected to a mains socket.
9
Switch the device off and
Always keep the device
to a mains socket.
9
into the charging
3
and
8