Special Safety Advice For Working With Wire Brushes; Safety Advice Applicable Specifically To Cordless Multi-Grinders - Parkside PFBS 10.8 A1 Betriebsanleitung

General safety advice for electrical power tools
comes to a complete stop. Never attempt
to remove the cut-off wheel from the
cut while the wheel is in motion other-
wise kickback may occur. Investigate and
take corrective action to eliminate the cause of
wheel pinching or snagging.
f) Do not restart the cutting operation in
the workpiece. Let the wheel reach full
speed and carefully re-enter the cut.
The wheel may bind, walk up or kickback if
the power tool is restarted in the workpiece.
g) Support panels or any oversized work-
piece to minimize the risk of wheel
pinching and kickback. Large workpieces
tend to sag under their own weight. Supports
must be placed under the workpiece near the
line of cut and near the edge of the workpiece
on both sides of the wheel.
h) Use extra caution when making a
"pocket cut" into existing walls or
other blind areas. The protruding wheel
may cut gas or water pipes, electrical wiring
or objects that can cause kickback.
Special safety advice for
working with wire brushes
a) Bear in mind that wire brushes lose
pieces of wire during normal use. Do
not overload the wires by applying too
much pressure. Flying pieces of wire can very
easily penetrate thin clothing and / or skin.
b) Allow brushes to run at operating speed
for at least one minute before using
them. During this time no one is to stand
in front or in line with the brush. Loose
bristles or wires will be discharged during the
run-in time.
c) Direct the discharge of the spinning wire
brush away from you. Small particles and
tiny wire fragments may be discharged at high
velocity during the use of these brushes and
may become imbedded in your skin.
26 GB
Safety advice applicable specif-
Q
ically to cordless multi-grinders
W hen you use the drill / grinder wear the fol-
lowing protective equipment: safety glasses
and protective gloves.
CAUTION! RISK OF INJURY! The tool
continues to rotate after it has been switched
off! Avoid contact with rapidly rotating drill /
grinder components.
piece. Use clamps or a vice to grip the workpiece
firmly. This is much safer than holding it in your
hand.
support yourself by placing your hands near or
in front of the device or the workpiece surface.
A slip can result in injury.
D ANGER OF FIRE FROM FLYING SPARKS!
Abrading metal creates flying sparks. For this
reason, always make sure that nobody is placed
in any danger and that there are no inflammable
materials near the working area.
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
I ts use as a saw or the use of saw blades with
this device is prohibited.
D o not soak the materials or the surface you
are about to work on with liquids containing
solvents.
A void abrading paints containing lead or other
substances hazardous to health.
D o not machine materials containing asbestos.
Asbestos is a known carcinogen.
A void contact with moving sanding or grinding
tools.
D o not machine moist materials or damp sur-
faces.
NOTE! Do not allow the tool to come to a stand-
still by overloading it!
Securely support the work-
RISK OF INJURY! Never
DUST HAZARD! Any
NOXIOUS FUMES!