Cooling/Heating/Fan Only Operation; Dry Operation - Toshiba RAS-M10YDCV-E Betriebsanleitung

COOLING/HEATING/FAN ONLY OPERATION

Start
1
START/STOP button
Push this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool , Heat
3
Temperature button
Set the desired temperature.
Cooling 21°C or higher.
Heating 28°C or lower.
When the air conditioner is in FAN ONLY operation, the temperature
display is not indicated.
4
Fan speed button (FAN)
Select one of "AUTO", LOW
HIGH .
• The OPERATION lamp (green) on the switch panel of the indoor unit
goes on. And operation starts after approximately 3 minutes.
(If you select FAN ONLY mode, the unit will start immediately.)
• The : Fan only mode does not control temperature.
Therefore, perform only steps
Stop
START/STOP button
Push this button again to stop the air conditioner.

DRY OPERATION

Start
1
START/STOP button
Push this button to start the air conditioner.
2
Mode select button (MODE)
Select DRY
3
Temperature button
Set the desired temperature.
• The fan speed display indicates AUTO.
• The OPERATION lamp (green) on the switch panel of the indoor unit
lights, and operation starts after approximately 3 minutes.
Stop
START/STOP button
Push this button again to stop the air conditioner.
, or Fan only . (For cooling only model)
, LOW + , MED
1 2 4
, and to select this mode.
, MED + ,
10
˚ C
AM
:
3
AUT UTO
PRESET
1
START/STOP
4
FAN MODE AUTO
2
SWING ECO Hi-POWER
TIMER TIMER
FIX MEMO
ON OFF SET CLR
FILTER
RESET CLOCK CHECK
˚ C
AM
:
AUT UTO
3
PRESET
1
START/STOP
FAN MODE AUTO
2
SWING ECO Hi-POWER
TIMER TIMER
FIX MEMO
ON OFF SET CLR
FILTER
RESET CLOCK CHECK