Installation - Nice DBM5 Anweisungen Und Hinweise Für Den Installateur

Warnings
• This instruction manual contains important information regarding safe
installation. Read all the instructions before proceeding with the instal-
lation. Save this manual for future reference.
• This manual is has been especially written for use by qualified installa-
tion technicians.
No information given in this manual can be considered as being of any
interest to end users!
1) Description and intended use of the product
DBM is a mechanical device consisting of an aluminium guide in
which a cable holding chain has been inserted, enabling the electri-
cal connection of one or two safety sensitive edges installed on
doors or gates with linear movement, such as the leaves of sliding
gates.
The aluminium guide must be mounted on the entire length of the
leaf. It comes in lengths of 2.5 meters which can be joined together
using the pins provided for this purpose.
Figure 1 shows an example of DBM installation on a typical auto-
matic gate.

2) Installation

1. Check the minimum distances between the post and the ends of
the guide with the leaf in the fully open and fully closed position,
as shown in figures 2 and 3.
2
2. Determine at which height on the leaf the aluminium guide must
be mounted, and the position of the post, considering the dimen-
sions shown in figure 4
4
To prevent needless torsional stress on the post, mount
!
the aluminium guide as low as possible
2
3
Max 95mm - Min 55mm
• Any use of DBM other than that described in this manual is forbidden;
improper use can be dangerous and cause personal injury or damage
to property.
• Do not modify any parts other than as described in these instructions;
operations of this type can only cause malfunctions; NICE disclaims all
responsibility for damages resulting from modified products.
• The packaging materials for DBM must be disposed of in compliance
with the regulations locally in force.
3. Make sure that there is enough room on the leaf for mounting the
guide.
The guide must be mounted in a perfectly horizontal posi-
!
tion and must be absolutely straight.
4. To mount the first section of aluminium guide on the leaf you need
to drill holes at intervals of 50 cm along the upper edge and use
screws that are suited to the leaf material.
5
5. Using 3 of the pins provided for this purpose, join the second sec-
tion of aluminium guide and proceed in the same manner for any
other sections required. When you reach the end of the leaf, cut
any excess guide off .
6
1