Accessories - Johnson Pump SPXFLOW Ultima Combo 500 GPH Bedienungsanleitung

> English

Accessories

Panel 12V or 24V
12V
Part No 34-1224
The SPX FLOW Johnson Pump panel combined with the
Ultima Switch gives you an excellent installation for your
boat.
The panel switch has 3 positions: OFF, MAN (on manual),
and AUTO (on automatic). It also includes a fuse holder and
a pilot lamp.
Fuses are not included. Fuse is selected according to the recommended fuse size of
the connected pump, refer to the pump manual.
The panel is delivered in matt black finish.
Size: 73 x 60 mm
Electrical installation with the SPX FLOW Johnson Pump panel
1. Always install according to the wiring diagram on page 18.
2. With the switch in AUTO-position, the pump will now start when the bilge water
reaches 50 mm and stops when it comes down to 20 mm. You can also run the
pump "manually". Note: When running the pump in "Manual"- position, it must not
run dry. When the pump is running, the pilot lamp will be lit.
3. The size of the fuse should be chosen according to the specifications of each
pump size.
4. Important: All electrical wiring must be clamped with the connections well above
the bilge water level. Do not remove the insulation more than necessarily. All wiring
connections should be sealed with a marine sealant to avoid oxidation.
8
24V
34-1225
Original instructions