Control Board - EuroLite AKKU TL-3 TCL Trusslight QuickDMX Bedienungsanleitung

Battery status
The battery charging status is indicated on the display. The battery charging status is indicated by four
levels. If all four levels are lit, the battery is fully loaded. If only one level is lit, the red one, the battery is
going flat soon. In this state, the device can be operated for a few minutes. Then an emergency switch-off
deactivates the device to protect it from total discharge.

Control Board

The Control Board offers several features: you can simply set the starting address, run the pre-programmed
program or select a DMX channel mode.
Menu
Menu level 2
level 1
Addr d001-d512
CHnd 3CH, 5CH, 8CH
SLAU SL.AU
SP-- SP00-SP99
Pr-- Pr00-Pr15
ASC- AC00-AC99
FAdE FA00-FA99
FLAS FL00-FL99
rL-- r000-r255
GL-- G000-G255
bL-- b000-b255
SoUA SO.UA
LEd oF10/oF30/oF60/oF90
nodE nod0-nod4
UErn UEX.X
POU- PO-1/PO-2
The main menu is accessed by pressing Menu. Browse through the menu by
pressing Up or Down. Press Enter in order to select the desired menu. You can
change the selection by pressing Up or Down. Press Enter in order to confirm.
You can leave every mode by pressing Menu. The functions provided are listed
in the following sections.
Description
DMX address setting
Setting DMX channel mode
Slave Mode
Select the desired program speed
S00 – S99 (increasing)
Preset colors
00 Red
01 Green
02 Blue
03 Red + green
04 Green + blue
05 Red + blue
06 Red + green + blue
07 Red + strobe
Switching colors
AC00-AC99 (with increasing speed)
Fading colors
FA00-FA99 (with increasing speed)
Strobing colors
FL00-FL99 (with increasing speed)
Dimmer intensity of red LED color
000 – 255 (increasing)
Dimmer intensity of green LED color
000 – 255 (increasing)
Dimmer intensity of blue LED color
000 – 255 (increasing)
Sound controlled mode
Display shutoff
Shuts off the display after about 10, 30, 60 or 90 seconds
Dimmer speed (step response)
node0: Response characteristics of LEDs
node1: Response characteristics of halogen lamps, fast
node2: Response characteristics of halogen lamps, less fast
node3: Response characteristics of halogen lamps, middle
node4: Response characteristics of halogen lamps, slow
Software version
Power-save mode
PO-1 - power save mode, 50 % power
PO-2 - full power
08 Green + strobe
09 Blue + strobe
10 Red + green + strobe
11 Green + blue + strobe
12 Red + blue + strobe
13 Red + green + blue + strobe
14 RGB Color Change
15 P00-P06 Color Change
37/44 00106543, Version 1.0