Ec Declaration Of Conformity; General Power Tool Safety Warnings - Makita DCS553 Betriebsanleitung

a
of
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value
ways
tool is used.
WARNING:
identify
protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking
account of
the
as
switched off and when it is running idle in addition to
the trigger time).

EC Declaration of Conformity

For European countries only
The EC
conformity is
Annex
manual.
SAFETY WARNINGS

General power tool safety warnings

WARNING:
Read all safety warnings,
instructions, illustrations and specifications
provided with this power tool. Failure to follow all
instructions listed
in
and/or
Save all warnings and
instructions for future reference.
The term
the
your
power
operated (cordless) power tool.
preliminary assessment
exposure.
depending on
in which
Be sure
safety measures to
all parts
operating cycle
the times when the tool is
declaration of
included
A to this instruction
below may
electric shock,
serious injury.
"power tool"
warnings refers
mains-operated
tool or
Cordless Metal Cutter safety
warnings
Cutting procedures
1.
area and the blade. Keep your second hand
on auxiliary handle, or motor housing. If both
hands are holding
the
the 2. Do not reach underneath the workpiece. The
guard
to
3. Adjust the cutting depth to the thickness of
the workpiece. Less than a full tooth of the
blade teeth should be visible below the
of
workpiece.
such
4. Never hold the workpiece in your hands or
across your leg while cutting. Secure the
workpiece to a stable platform. It is important
to support
5. Hold the power tool by insulated gripping
surfaces, when performing an operation
as
where the cutting tool may contact hidden
wiring. Contact with a "live" wire will also make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
6. When ripping, always use a rip fence or
straight edge guide.
the chance of blade binding.
7. Always use blades with correct size and
shape (diamond versus round) of arbour
holes. Blades that do not match the mounting
hardware of the saw will run off-centre, causing
loss of control.
8. Never use damaged or incorrect blade
result
washers or bolt. The blade washers and bolt
fire
were specially
Kickback causes and related warnings
in
—
to
kickback is a sudden reaction to a pinched,
(corded)
jammed
battery-
workpiece toward the operator;
—
when the
7 ENGLISH
DANGER: Keep hands away from cutting
they cannot
by the
cannot
from the
the workpiece.
the
to minimise
exposure, blade binding, or loss of control.
the accuracy
designed for
saw, for
performance
of operation.
or
blade, causing
uncontrolled saw to lift up and out of the
blade
or jammed
the kerf closing down, the blade
the saw,
be cut
blade.
protect you
blade below
work properly
body
This improves
of cut and reduces
your
optimum
and safety
misaligned saw
an
is pinched
tightly by