Overheat Protection; Overdischarge Protection - Makita DCS553 Betriebsanleitung

Overheat protection

When the
overheated,
stops
the
about
situation, let the tool cool down before turning the tool
on again.
On

Overdischarge protection

When the
low,
automatically.
product
even
operated, remove the batteries from the tool and
charge the batteries.
Releasing protection lock
When the
repeatedly, the
locked
indicator
state.
Blinking
In this situation, the tool does not start even if turning
the tool off and on. To release the protection lock,
remove the
to
and
charging
Indicating the remaining battery
capacity
When you
trigger,
indicator
remaining battery
Fig.2: 1. Battery
The remaining battery
shown
table.
tool/battery is
the tool
automatically, and
battery indicator blink
60 seconds. In this
Blinking
battery capacity becomes
the tool stops
If the
does not operate
when the switches are
protection system works
tool is
and the battery
shows the following
Off
battery, set it
the battery charger
wait until the
finishes.
pull the switch
the battery
shows the
capacity. ►
indicator
capacity is
as the following
Battery indicator status
On
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
►
Fig.3:
button
Press the
the
indicate
capacity.
light up for a few seconds.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature,
indication may
from
11 ENGLISH
Off
Blinking
1. Indicator lamps 2. Check
check button
battery cartridge
the remaining battery
The indicator
Off Blinking
the
differ
the actual
Remaining
battery
capacity
50 % to 100%
20 % to 50%
0 % to 20%
Charge the
battery
on
to
lamps
Remaining
capacity
75 % to 100%
50 % to 75%
25 % to 50%
0 % to 25%
Charge the
battery.
The
may
ba
malfunctioned.
slightly
capacity.