Operation - Makita DCS553 Betriebsanleitung

blade 4.
washer
To install the circular saw blade, follow the removal
procedure in reverse.
WARNING:
BE SURE TO TIGHTEN THE HEX
BOLT SECURELY. Also be careful not to tighten
the bolt forcibly. Slipping your hand from the hex
wrench can cause a personal injury.
WARNING:
If the inner flange is removed,
be sure to install it on the spindle. When
installing, choose a correct side on which
protrusion fits into the circular saw blade hole
perfectly. Mounting the circular saw blade on the
wrong side can result in the dangerous vibration.
Blade guard cleaning
When changing the circular saw blade, make sure to
also clean the upper and lower guards of accumulated
metal chips as discussed in the Maintenance section.
Such efforts do not replace the need to check lower
guard operation before each use.

OPERATION

CAUTION:
Always wear eye protection or
goggle before operation.
CAUTION:
Be sure to move the tool forward
in a straight line gently. Forcing or twisting the tool
will result in overheating the motor and dangerous
kickback, possibly
CAUTION:
Never twist or force the tool in the
cut. This
overload
dangerous kickback, resulting
serious
operator.
CAUTION:
Always use the circular saw blades
appropriate for your job. The use of inappropriate
circular saw
a
performance
a
injury.
CAUTION:
Do not use a deformed or cracked
circular saw blade. Replace it with a new one.
►
Fig.17
Hold the
tool
both
rear handle. Use both to best grasp the tool. If both
hands
tool,
cut
Inner flange 5. Cup
causing severe
may cause
and/or a
injury to
blades may
poor cutting
and/or
risk of
tool firmly. The
is provided with
a front grip and
are holding the
they cannot be
by the circular saw
blade. Set the base on the workpiece to
the circular saw
Doing so may
stop and then withdraw tool. Realign tool on new cut
line, and start cut again. Attempt to avoid positioning
which exposes operator to chips and
injury.
The
motor
between the front edge of the circular saw blade and
in
the workpiece whenever the circular saw blade is set
the to the maximum depth of cut. ► Fig.18:
Cutting line 2. Base 3. Sight grooves
CAUTION:
them.
cause
CAUTION:
plastics, concrete, tile, etc. Cut only mild steel,
present
aluminum and stainless steel with a suitable
personal
circular saw blade.
CAUTION:
blade, workpiece or cutting chips with bare hands
immediately after cutting.
CAUTION:
until the battery cartridge has discharged, allow
the tool to rest for 15 minutes before proceeding
with a fresh battery.
14 ENGLISH
cut without the
saw blade making
contact. Then turn the tool on and wait until
blade attains
speed. Now simply
the tool forward
the workpiece surface,
it flat and
advancing smoothly until
cutting is completed. To
get clean cuts,
your cutting line
and your speed
advance uniform. If
cut fails to
follow your intended
line, do not
to turn or force the tool back to the cut line.
bind the
saw blade and
to dangerous kickback
possible serious injury.
switch, wait for the circular saw blade to
being ejected from
tool. Use eye
protection to help
injury.
sight grooves in
base makes it
to check the distance
Do not stack materials when cutting
Do not cut hardened steel, wood,
Do not touch the circular saw
be extremely hot
could burn
If the tool is operated continuously
be
circular
any
full
move
over
keeping
the
keep
straight
of
the
properly
cut
attempt
circular
lead
and
Release
particles
the
avoid
the
easy
1.
They may
and
your skin.