Makita DCS553 Betriebsanleitung Seite 12

Switch action
WARNING:
Before installing the battery
cartridge into the tool, always check to see that
the switch trigger actuates properly and returns to
the "OFF" position when released.
WARNING:
NEVER defeat the lock-off button
by taping down or some other means. A switch with
a negated
result
operation and
injury.
WARNING:
NEVER use the tool if it runs when
you simply pull the switch trigger without pressing
the lock-off button.
need
result
operation and
injury.
a
proper repairs BEFORE further usage.
To prevent
from being
a lockoff button is provided. To start the tool,
depress the lock-off button and pull the switch trigger.
Release the switch trigger to stop. ►
1. Switch trigger 2. Lock-off button
NOTICE:
Do not pull the switch trigger hard
without pressing in the lock-off button. This can
cause switch breakage.
CAUTION:
The tool starts to brake the circular
saw blade rotation immediately after you release
the switch trigger. Hold the tool firmly to respond
the reaction of the brake when releasing the
switch trigger. Sudden reaction can drop the tool off
your
cause
Automatic speed change function
This tool has "high speed mode" and "high torque
mode". The
changes
depending on the work load. When the
work load is low, the tool will run in the "high speed
mode" for quicker cutting operation. When the work
load is high, the tool will run in the "high torque mode"
for powerful cutting operation. ► Fig.5:
indicator
The mode indicator lights up in green when the tool is
running in "high torque mode".
If the tool is operated with excessive load, the mode
indicator will blink in green. The mode indicator stops
blinking and
lock-off button
in unintentional
serious
A switch
of repair
in unintentional
serious
Return tool
Makita service center for
the switch trigger
accidentally pulled,
Fig.4:
hand and
a personal
tool automatically
the operation mode
1. Mode
then lights up
the tool.
On
may
personal
in
may
personal
to
Adjusting depth of cut
CAUTION:
always tighten the lever securely.
Loosen the lever and move the base up or down. At
the desireddepth
safer cuts, set cut depth so that no more than one
helps to reduce potential for dangerous
1. Lever 2. Loosen 3. Tighten
Sighting
can
Place
injury.
►
Base
Lighting the lamp
CAUTION:
source of light directly.
To turn on the lamp without running the tool, pull the
switch trigger without pressing the lock-off button. To
turn on the lamp with the tool running, press and hold
the lock-off button and pull the switch trigger. The lamp
goes out 10 seconds after releasing the switch trigger.
►
12 ENGLISH
or turns off
you reduce the
Mo de indicator status
Off Blinking
After adjusting the depth of cut,
of cut,
the base by
tightening the lever. For cleaner,
blade tooth projects
workpiece. Using proper cut depth
KICKBACKS which
injury. ►
cause personal
the alignment line
the base on
intended cutting line on the workpiece.
Fig.7: 1. Alignment line 2. Cutting line 3.
Do not look in the light or see the
Fig.8: 1. Lamp
if
load on
Operation
mode
High speed
mode
High torque
mode
Overload
alert
secure
below
can
Fig.6:
of
your