Makita DCS553 Betriebsanleitung Seite 13

NOTE: Use
to
off
the lamp. Be careful not to scratch the lens
of lamp, or it
illumination.
Dust box
CAUTION:
Do not touch saw dust and the
dust box with bare hands immediately after the
operation. They
extremely hot
burn
CAUTION:
Do not cut the material on which
thinner, gasoline, grease, or other chemicals are
applied. The saw dust of such materials can damage
the dust box and result in breakage which can cause
personal injury.
CAUTION:
Wear eye protection or goggle
when emptying the dust box.
Saw dust
the
Periodically
in the dust box before it gets full. Push the lever on the
dust box to open the lid. Dump the saw dust while the
rear of the tool faces downward. ►
1. Lid 2. Lever
►
Fig.10
Hook
Optional accessory
CAUTION:
Always remove the battery when
hanging the tool with the hook.
CAUTION:
Never hook the tool at high
locations or on the surfaces where the tool may
lose the balance and fall.
CAUTION:
Do not pull the tool downward
when it is hooked.
CAUTION:
Always fold the hook when
operating the tool.
The hook
hanging
temporarily. ►
Attach the hook with the screws as illustrated.
►
Fig.12: 1. Hook 2. Screw
To use
turn
it
position.
a dry cloth
wipe the dirt
the lens of
may lower the
may be
and
your skin.
is collected into
dust box.
dump the saw dust
Fig.9:
is convenient for
the tool
Fig.11
the hook, simply
the hook until
snaps into the open
When
closed position.
►
position
Electric brake
This tool is equipped with an electric blade brake. If the
tool
could
have tool serviced at a Makita service center.
CAUTION:
substitute for blade guard. NEVER USE TOOL
WITHOUT A FUNCTIONING BLADE GUARD.
SERIOUS PERSONAL INJURY CAN RESULT.
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Hex wrench storage
When not in use, store the hex wrench as shown in
the figure to
wrench
Installing or removing the circular
saw blade
CAUTION:
install or remove the circular saw blade.
CAUTION:
blade, be sure to tighten the bolt securely.
CAUTION:
installed with teeth pointing up at the front of the
tool.
►
Tighten
To remove the circular saw blade, press the shaft lock
fully
the hex bolt. Then remove the
►
13 ENGLISH
not in use,
turn the hook
it snaps into
Fig.13: 1. Open position 2. Closed
consistently fails
quickly stop the
saw blade after switch lever release,
The blade brake system is not a
Always be sure that the tool is
keep it
lost. ►
being Fig.14:
Use only the Makita wrench to
When installing the circular saw
Be sure the circular saw blade is
Fig.15: 1. Shaft lock 2. Hex wrench 3.
4. Loosen
so that the
saw blade cannot
and use the hex wrench to loosen
hex
outer flange and
saw blade.
Fig.16: 1. Hex bolt 2.
flange 3. Circular saw
always
until
the
to
circular
from
1. Hex
circular
revolve
bolt,
circular
Outer