Functional Description - Makita DCS553 Betriebsanleitung

CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been
in
bursting
personal
damage.
void
warranty
tool
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before
completely discharged. Always stop tool
operation and charge the battery cartridge
when you notice less tool power.
2. Never recharge a fully charged battery
cartridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room
temperature at 10 °C - 40 °C (50 °F - 104 °F).
Let a hot battery cartridge cool down before
charging it.
4. Charge the battery cartridge if you do not use
it for a long period (more than six months).
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery
cartridge firmly when installing or removing
battery cartridge.
the
battery
cause
off
result
the
cartridge
personal
►
Fig.1: 1. Red indicator 2. Button 3.
Battery
altered, may
the battery
causing fires,
injury and
It will
the Makita
for the
and charger.
Failure to
tool and
cartridge firmly
them to
your hands
in damage
tool and
and a
injury.
cartridge
To
front of the cartridge.
result
To
also
Makita
CAUTION:
fully until the red indicator cannot be seen. If not, it
CAUTION:
forcibly.
Tool / battery protection system
The
under one of the following conditions.
Overload protection
hold
the
When
may
slip
and
to
battery
tool to become overloaded. Then turn the tool on to
restart.
10 ENGLISH
remove the battery
slide it from
tool while sliding the button on the
install the battery
align the tongue
the battery cartridge
the groove in
housing and slip
into place. Insert
all the way
it locks in
with a little
If you can
the red indicator
the upper side
the button, it
not locked completely.
Always install the battery cartridge
may accidentally
out of
causing injury
or someone around
Do not install the battery cartridge
If the
not slide
it is
inserted correctly.
tool is equipped with
a tool/battery protection system.
This system automatically
cuts off power
the motor to
tool and battery
The tool will
automatically stop
operation if the
or battery is
the tool/battery is
in a manner
causes it to
an abnormally high
the tool automatically
stops. In this
turn the tool
and stop the application that caused the
cartridge,
the
cartridge,
on
with
the
it
it
until
place
click.
see
on
of
is
fall
the tool,
to you
you.
cartridge does
in easily,
not being
to
extend
life.
during
tool
placed
operated
that
draw
current,
situation,
off