Bosch 80+R60 Originalbetriebsanleitung Seite 33

OBJ_BUCH-1347-001.book Page 33 Friday, January 21, 2011 10:30 AM
Troubleshooting Causes and
–
Corrective Measures
Cause
Temperature warning indicator (k) flashing;
measurement not possible
The measuring tool is
outside the operating
temperature range from
– 10 °C to + 50 °C (in
the function continuous
measurement up to
+40 °C).
"ERROR" indication in the display
Addition/Subtraction of
measured values with
different units of meas-
ure
The angle between the
laser beam and the tar-
get is too acute.
The target surface re-
flects too intensely (e.g.
a mirror) or insufficient-
ly (e.g. black fabric), or
the ambient light is too
bright.
The laser beam outlet
16 or the reception lens
17 are misted up (e.g.
due to a rapid tempera-
ture change).
Calculated value is
greater than
2 3
999999 m/m /m .
Indication ">60°" or "<–60°" on the display
The inclination measur-
ing range for the meas-
uring mode and/or the
reference plane has
been exceeded.
Bosch Power Tools
Cause
"CAL" and "ERROR" indication in the display
The calibration of the
Corrective Measure
grade measurement was
not carried out in the
correct sequence or in
the correct positions.
Wait until the meas-
uring tool has
reached the operat-
The surfaces used for
ing temperature
the calibration were not
accurately aligned (hori-
zontal or vertical).
The measuring tool was
Only add/subtract
moved or tilted while
measured values
pressing the button.
with the same units
of measure
Enlargen the angle
Battery charge-control indicator (g), temper-
between the laser
ature warning (k) and "ERROR" indication in
beam and the target
the display
Work with the laser
Temperature of the
target plate 28 (ac-
measuring tool not with-
cessory)
in the allowable charge-
temperature range
Battery charge-control indicator (g) and
"ERROR" indication in the display
Wipe the laser beam
outlet 16 and/or the
Battery charging voltage
reception lens 17
not correct
dry using a soft
cloth
Divide calculation
into intermediate
steps
Carry out the meas-
urement within the
specified angle
range.
Battery charge-control indicator (g) and
clock symbol f in the display
Charge duration clearly
too long, as charging
current too low.
English | 33
Corrective Measure
Repeat the calibra-
tion according to
the instructions on
the display and in
the operating in-
structions.
Repeat the calibra-
tion on a horizontal
or vertical surface; if
required, check the
surface first with a
level.
Repeat the calibra-
tion and hold the
measuring tool in
place while pressing
the button.
Wait until the
charge-tempera-
ture range is
reached.
Check if the plug-in
connection has
been established
correctly and if the
battery charger is
operating properly.
When the unit sym-
bol is flashing, the
battery is defective
and must be re-
placed by a Bosch
after-sales service.
Only use the original
Bosch charger.
2 609 140 807 | (21.1.11)