Manual Tuning; Auto Tuning - JGC MS450-3CD Bedienungsanleitung

POWER AND SOURCE SELECT
POWER
Press Standby /on button and the stand-
by LED will light off when unit is on.
VOLUME
Adjusts loudness of speakers or
headphones
LISTENING TO THE RADIO

MANUAL TUNING

1. Press TUNER/BAND button to select desired BAND (AM or FM).
2. Tune to the required station by pressing the CD/TUNING button.
3. Adujst volume control to the desired volume level.

AUTO TUNING

1. Press TUNER/BAND button to select desired band (AM or FM).
2. Press and hold the
3. The unit will start scanning automatically and stops when a radio station is reached.
4. Repeat steps 3 & 4 until a desired radio station is reached.
5. Adjust volume control to a desired volume level.
PRESET STATIONS BY REMOTE HANDSET
You can store up to a total of 30 radio stations in the memory (20-FM / 10-AM).
1. Set to TUNER mode.
2. Turn to the desired radio station by "MANUAL" or "AUTO" tuning methods.
3. Press MEM/CLOCK button to enable programming state.
4. Press M-UP or M-DOWN button to select the desired station memory for storage.
5. Press MEM/CLOCK button again to confirm the setting.
6. Repeat steps 2 to 5 to store other stations.
7. To return to normal tuner mode, leave the keys alone.
8. Press M-UP or M-DOWN button to reload the preset stations in order.
HINTS FOR BEST RECEPTION:
AM: The receiver has a built-in AM ferrite antenna. If the AM reception is weak, rotate or reposition the
unit. This usually improves the AM reception.
FM: Attached FM wire antenna plugged in at the rear of the unit should be fully unwound and extended
its full length for best reception.
BASIC OPERATION & RADIO
button for 1 - 2 seconds and then release.
CD/TUNING
FUNCTION
Use to select desired source (TAPE, CD,
RADIO ) to be listened to. The selected
source is also available for recording.
Please consult RECORDING section of
this manual for more details.
22