JGC MS450-3CD Bedienungsanleitung Seite 28

TAPE DECK
RECORDING (DECK A ONLY)
This unit has an ALC (Automatic Level Control) circuit and no further adjustment of the controls
are necessary while recording.
1. Press the POWER switch to ON.
2. Set the desired FUNCTION selector according to the source to be recorded.
3. Press the STOP/EJECT button to insert a blank tape.
4. Press the RECORD/PLAY button to start recording.
5. Since you can monitor through the speakers regardless of the recording level, adjust the
VOLUME controls to the desired sound level and sound equalisation.
6. Press the STOP/EJECT button to stop recording at any time. When the end of the tape has
been reached, the automatic stop will be activated.
NOTE:
Noise may be heard if recording from AM Radio station, to reduce this noise please slide the
BEAT CUT Switch.
DUBBING (DECK B TO DECK A)
This unit enables you to duplicate a pre-recorded tape to another tape by using the double deck
mechanisms. It is performed only one way, from the DECK B (playback) to DECK A (recording).
REMARKS: HIGH-NORMAL SPEED DUBBING SWITCH IS ON THE REAR SIDE OF THE UNIT.
DUBBING AT NORMAL SPEED
NOTE: Be sure the DUBBING switch is set to NORMAL in order to record at normal speed.
1. Press the POWER switch to ON.
2. Press TAPE button to select TAPE mode.
3. Insert a pre-recorded cassette into the DECK B and a blank cassette into the DECK A.
4. Press the DECK A PAUSE button and then press the RECORD button.
5. Press the DECK B PLAY button to start dubbing.
6. Adjust the VOLUME controls to the desired sound level and sound equalisation.
DUBBING AT HIGH SPEED
This unit is equipped with a HIGH SPEED DUBBING system which allows duplicating a
pre-recorded tape at approximately two times the normal speed. Slide the DUBBING switch to
HIGH setting, and follow the same procedure as instructed in DUBBING AT NORMAL SPEED.
When dubbing a pre-recorded cassette tape at high speed in TAPE function, a chattering sound is
heard. To avoid this, set the VOLUME control to a minimum or select any other source to be
listened to.
NOTE:
While high speed dubbing is in progress, do not change the DUBBING switch setting, since this
will vary the speed of the program and ruin the recording.
27