Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GENERAL INFORMATION ON RECORDING
•
Recording is permissable in so far as copyright or other rights of third parties are not infringed.
•
This deck is not suitable for recording on CHROME (IEC II) or METAL (IEC IV) type cassettes. For
recording, use NORMAL (IEC I) type cassettes on which the tabs have not been broken. The best
recording level is set automatically. Altering the VOLUME will not affect the recording in progress.
•
At the very beginning and end of the tape, no recording will take place during the 7 seconds, when the
leader tape passes the recorder heads.
•
To protect a tape from accidental erasure, have the tape in front of you and break out the left tab.
Recording on this side is no longer possible. To record over this side again, cover the tab hole with a
piece of adhesive tape.
SIDE A
Protection tab
CHECKING THE CASSETTE
•
Make sure that the cassette tape has no slack prior to inserting it into the recorder. Unless the tape is
taut, it may wind around the head mechanism and trouble may result. Use a pencil as shown in the
Figure above to take up slack on one of the reels.
•
We do not recommend the C-120 casettes because they can be subject to mechanical instability and
proper constant tape tension cannot be controlled.
TAPE DECK MAINTENANCE
To ensure quality recording and playback of the tape deck, clean parts [A], [B] and [C] after approx. 50
hours of operation or on average once a month. Use a cotton bud slightly moistened with alcohol or a
special cleaning fluid
1. Open the cassette door by pressing STOP/EJECT.
2. Press PLAY and clean the rubber pressure roller [C]
3. Press PAUSE and clean the magnetic heads [A] and the capstan [B]
4. After cleaning, press STOP/EJECT and close the cassette door.
NOTE: Cleaning of the heads can also be done by using a special head cleaning cassette.
Adhesive tape
TAPE DECK
28
Werbung
Inhaltsverzeichnis
