Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as
there is a risk of electric shock.
If you are unable to remedy the problem by following these hints, call service and support at the phone
number shown below.
Warning: Under no circumstances should you try to repair the set yourself, as this will invalidate the
warranty
Problem
No sound / power
Display does not function properly / No
reaction to operation of any of the controls
The CD skips tracks
No disc indication
CD Playback does not work
Service & support hotline: 0180 5 - 22 17 84 (€ 0,12 / Min.) (Germany only)
If the product needs to be sent to the servicecenter, please use the provided
return sticker. If the sticker is missing, please call service & support.
SERVICE & SUPPORT
Cause
Volume not adjusted
Power cord not securely connected
Electrostatic discharge
CD damaged or dirty
Program is active
No CD inserted
CD badly scratched or dirty
Laser lens has steamed up
CD-R is blank or the disc is not finalized
CD badly scratched or dirty
Laser lens steamed up
Solution
Adjust the Volume
Connect the AC cord properly
Switch off und aunplug the set. Reconnect after a
few seconds
Replace or clean CD
Quit program mode
Insert a CD, CD-R or CD-RW
Replace or clean CD
Wait until lens has cleared
Use a finalized CD-R
Replace or clean CD
Wait until lens has adjusted to room temperature
30
Werbung
Inhaltsverzeichnis
