Ironing Without Steam - Philips Supervapor GC6048 Bedienungsanleitung

ENGLISH
10
ironing the articles requiring the lowest temperature such as those
made of synthetic fibres.Then progress to the higher temperatures.
Pure woollen fabrics may be pressed with the iron set to a steam
position. It is recommended to apply shot-of-steam and use a dry
pressing cloth.
When steam-ironing woollen fabrics, shining of the fabric may occur.
This can be prevented by turning the article inside out and ironing the
inside.
Velvet and other fabrics that tend to acquire shiny patches, should
be ironed in one direction only (along with the nap) while applying
very little pressure.
Do not use steam when you are ironing coloured silk.This could
cause stains.
Steam ironing
1 Set the temperature dial to the recommended position.
See 'Setting the temperature'. Steam-ironing is only possible at higher
ironing temperatures: Set the dial to 2 or 3.
Steaming will start as soon as the set temperature has been reached.
B
C
2 While steam-ironing, keep the steam activator (M) pressed in.
3 During steam-ironing the two pilot lights (D) and (K) will go on
from time to time.When this happens either the iron or the
steam tank is being heated-up to the required temperature.You
can continue ironing.

Ironing without steam

1 Set the temperature dial to the recommended position.
See 'Setting the temperature'.
2 Do not press-in the steam activator button (M).
3 Switch off the steam tank by setting switch 'Steam tank on/off'
≤ (D) to position O.
If you press the steam button by accident when you are ironing,
some steam will escape. In case the tank is empty or not heated up
yet, a clicking sound will come from the water tank.This
phenomenon, caused by the opening of the steam valve, is
harmless.
If you have been ironing at a high temperature and subsequently
set the temperature control (N) to a lower setting, wait until the
temperature pilot light (K) goes on again before you continue
ironing.This will prevent damage to fabrics.