English; General Description - Philips Supervapor GC6048 Bedienungsanleitung

ENGLISH

6

General description

A) Steam tank
B) Filling opening with screw cap
C) Variable steam knob (types GC6044/6046/6048 only)
D) Pilot light 'Steam tank heating up' (U) The pilot light goes out
when the appliance is ready for steam-ironing. Switch 'Iron on/off'
(≥) with integrated pilot light
E) Switch 'Steam tank on/off' (≤) with integrated pilot light
F) Switch 'Iron on/off' (≤) with integrated pilot light
G) Manometer (to verify steam pressure). Needle in the green area:
sufficient steam pressure (Types GC6048/6048 only)
H) Supply hose
I) Mains cord
J) Iron + supply hose storage lock
K) Pilot light 'Iron heating up'
L) Push button "Jet of Steam" (Types GC6048/6048 only)
M) Steam activator (press-in for steam ironing)
N) Temperature dial (rotate). Steam control (rotate)
Position 1: minimum steam output
Position 5: maximum steam output (Types 6044/6046/6048 only)
O) Soleplate
P) Iron stand (removable)
Q) Button groove with frontal jet of steam holes
R) Anti-calc funnel (type 6048 only)
S) Mains cord wind facility
Important
For optimal safety, read these instructions carefully and look at the
illustrations before you start using the appliance.
- Do not put perfume, vinegar, descaling agents or other chemicals in
the water tank.
- Never use the appliance if it is damaged in any way. Regularly check if
the mains cord and the supply hose are still undamaged and safe.
- If the mains cord of this appliance is damaged, it must always be
replaced by Philips or a service centre authorised by Philips, as
special tools and/or parts are required.
- Use only the cap of the steam tank that has been supplied with the
appliance, as this cap also functions as a safety valve.
- Check if the voltage indicated on the bottom of the steam tank
corresponds to the mains voltage in your home before you connect
the appliance.
- Only connect the appliance to an earthed wall socket.
- Never immerse the iron or the steam tank in water.
- Never leave the iron unattended when it is connected to the mains.
- When you have finished ironing and even when you leave the iron
for a short while, unplug the iron and put it on its iron stand.
- Always place the steam tank on a stable, level and horizontal surface.
Do not put the steam tank on the soft part of the ironing board.