Herunterladen Inhalt Inhalt Diese Seite drucken

Ironing Without Steam - Philips Supervapor GC6048 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Supervapor GC6048:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 15
ENGLISH
10
When steam ironing woollen fabrics, shiny patches may occur.You
can prevent this by using a dry pressing cloth and the jet-of-steam
function or by turning the article inside out and ironing the
reverse side.
The iron heats up faster than it cools down.You should therefore
start ironing the articles that require the lowest temperature, such
as those made of synthetic fibres.Then continue ironing at higher
temperatures.
Velvet and other fabrics that tend to acquire shiny patches, should
be ironed in one direction only (along with the nap) while applying
very little pressure.
Do not use steam when you are ironing coloured silk.This could
cause stains.
Steam ironing
1
Set the temperature dial to the recommended position.
See 'Setting the temperature'. Steam ironing is only possible at higher
ironing temperatures: set the temperature dial to 2 or 3.
Steam output will start as soon as the set temperature has been
B
reached.
C
2
While steam ironing, keep the steam activator button (M)
pressed in.
3
During steam ironing the two pilot lights (D) and (K) will go on
from time to time.When this happens, either the iron or the
steam tank is being heated up to the required temperature.You
can continue ironing.

Ironing without steam

1
Set the temperature dial to the recommended position.
See 'Setting the temperature'.
2
Do not press the steam activator button (M).
Switch off the steam tank by pushing the 'Steam tank on/off' ≤
3
switch (D) to set it to position O.
Some steam will escape if you press the steam activator button
(M) by accident while you are ironing. If the tank is empty or is not
heated up yet, you will hear a clicking sound inside the steam tank.
This phenomenon is caused by the opening of the steam valve and
is harmless.
If you have been ironing at a high temperature and subsequently
set the temperature dial (N) to a lower setting, wait until the 'iron
heating up' pilot light (K) goes on again before you continue
ironing.This will prevent damage to fabrics.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis