Herunterladen Inhalt Inhalt Diese Seite drucken

Craftsman 25043 Anleitungshandbuch Seite 27

Inhaltsverzeichnis

Werbung

o!
I\1
(_
1. Light switch
(_
1. Lichtschalter
1. Interrupteur des phares
_)
1.1nterruptor dealumbrado
(_
1.1nterruttore luci
(_
1. Schakelaar veriichting
3
@
®
2. Throttle/Choke
control
The accelerator control regulates the motor speed and also
the speed of the blades. If the lever is in itsforward position
the choke function is connected. If the lever is in its reverse
position the motor is in neutral. Full speed lies between
these two positions.
2. Gas- und Kaltstarthebel
Mit dem Geshebel wird die Drehzahl des Motors und damit
auch die Drehgeschwindigkeit der M&hklingen geregelt.
Mit dem Hebel in seiner vordersten Stellung ist die Kaltstart-
funktion eingeschaltet. Mit dem Hebel in der hintersten
Stellung I_uft der Motor im Leedauf. Zwischen die,senbeiden
Endstell-ungen
liegt die Vollgasstellung.
®
2. Commande
de et starter
La commande de gaz permet de rC=glerle regime moteur et
doric la vitesse de rotation des lames.
En poussant
la
manette tout en haut, on enclenche le starter.
Quand on
ramene la manette tout en bas, le moteur tourne au ralenti.
Entre ces deux positions maxi, se trouve le r_jime optimal
pour la tonte, signal_ par une encoche dans le rail ou se
d_piace la manette.
(_)
2. Mandos
del acelerador
y dql estrangulador
Con el acelerador se regulan las revoluciones del motor y
con elias tambidn la velocidad de rotaci6n de las'cuchillas.
Si la palanca estd en su posici6n delantera, estard acoplada
la funci6n de estrangulaci6n.
"Si la palanca
estd en su
posici6n trasera, el motor marchard en ralenff. Entre estes
dos posicio-nes
extremas est,. la de pleno gases.
Q
2. Comando
gas/choke
Questo comando aumenta o diminuisce il regime di gid del
motore. Premere la leva completamente in avanti per Io
choke. Tirare la leva completamente indietro per il minireo.
II gas massimo si trova in una posizione intermedia.
2. Gas- en chokehendel
Met de gashendel wordt het toerental van de motor geregeld
en daardoor ook de rotatiesnelheid van de messen. Is de
hendel in de voorste stand gezet, is de chokefunctie
ingescha-keld. Staat de hendel in de achterste stand, Ioopt
de motor stationair. Tussen deze beide buitenposities ligt de
vol-gas stand.
27

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis