Troubleshooting; Maintenance / Cleaning - indexa SYSTEM 3000 BASIC Bedienungsanleitung

# Walls and floors, especially those containing metal, metalised foil,
reinforced concete or stone
# Coated windows (eg. Energy saving windows), radiators, refridgerators,
mirrors, metalic surfaces or doors
# Electrical wiring and electrical appliances (eg. motors, microwave
ovens)
# Devices using the same or similar wireless frequency.

16. Troubleshooting

Fault Cause
short wireless range antenne is covered do not cover the front of the
of remote control
Alarm without PIR-detector reacts check positioning of PIR,
apparent reason to temperature
differences
PIR-detector does In operating mode Wait, or press the test
not react deactivated for up
to 5 minutes after
each detection
siren no longer reacts detector or remote
to detector or control is no longer components
remote control enrolled; e.g.
jumper position
has been changed
17. Maintenance + cleaning
# Regularly check the technical safety and function
# Before you clean the device, pull the mains adapter out of the mains
socket and remove the batteries.
# Use a soft, dry or slightly moist cloth or a dry brush for cleaning the
surfaces.
18. Optional accessories
# 3000M, Door/window contact, Art.Nr.33531
# 3000R, Remote control, Art.Nr. 33532
# 3000P, PIR-detector, Art.Nr. 33530
# 3000 Set F4, GSM-wireless alarm system, Art.Nr. 33523
19. Enrolling further components to the siren
Use ear protection
! Use a ball point pen to press the connect button (6) on the siren. The
siren beeps and the LED (3) lichts yellow/orange for 10 seconds. Within
this period you can enroll one of the following components:
# Remote control: press the disarm button (12) once
# PIR-detector: press the test button (23) twice
# door/window contact: trigger by separating magnet from the sensor
The enrollment will be confirmed by the siren with a beep and LED (3)
will flash.
30
Remedy
remote control
do not point towards heat
sorces
button (23). After the
deactivation period the
unit will detect immediately
reset the siren and enroll all
20. Delete all components (Reset)
If a remote control is lost, delete all components and then enroll the
remaining components again (see chapter 19), to maintain the security of
the system.
! To delete all remote controls and detectors hold the connect button (6)
on the siren with a ball point pen pressed until the deletion is confirmed
by a beep and flash.
Tip:
Enroll a remote control as the first item, by pressing the disarm button (12)
2 times, then you can cancel an unwanted alarm.
21. Disposal
Packaging material, used batteries or electrical products must not be
disposed of as household waste. Use your recycling system. Details
are available from your local authority.
22. Simplified EU d
conformity
Hereby, INDEXA GmbH declares that the radio equipment type 3000 SET F3
is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
http://www.pentatech.de/de/downloads/cat_view/13-ce-
erklaerungen.html.
eclaration of