Getting Started; Replacing Battery; Weighing - Silvercrest HG01696A Bedienungs- Und Sicherheitshinweise

acid, rinse the affected area with
plenty of clean water and consult
a doctor immediately.
Remove light dirt from the battery
and product contacts with a dry,
non-fluffing cloth before inserting
the battery.
Remove the battery from the
product if it is not in use for any
length of time.
Make sure that the polarity is cor-
rect when you insert the battery.
This is indicated in the battery
compartment. The battery can
otherwise explode.
Insert the battery with care.
The product can otherwise be
damaged.
Please do not dispose of used
batteries in your household waste
but take them to a designated
collection depot for special waste.

Getting started

Q
1. Loosen the screw located at the back of the kit-
chen scale by using a screw driver.
2
2. Open the battery compartment
of the kitchen scale
the battery compartment cover
battery compartment
3. Remove the isolating strip. This is located
between the battery and the battery compart-
ment .
8
4. Replace the battery compartment cover
the battery compartment
the two extensions on the battery compartment
on the back
8
by pushing the clip of
2
towards the
9
and lift the cover off.
8
9
. Make sure that
8
cover engage in the two openings in the
9
battery compartment
compartment cover
partment
8
clicks into place.
5. Close the battery compartment
the screw by using a screw driver.

Replacing battery

Q
1. Loosen the screw located at the back of the kit-
chen scale
2. Open the battery compartment
3. Remove the used battery from the battery com-
partment
8
wards. Make sure that you do not exert too
much pressure on the grip
wise be damaged.
Remove the battery from the battery compart-
ment .
8
4. Insert the new battery. Make sure that the polarity
is correct. The "+" must be pointing upwards.
The battery must be pressed inside the battery
holder.
5. Close the battery compartment
the screw by using a screw driver.

Weighing

Q
Note: Starting with or without the weighing bowl
, the kitchen scale
1
oz (the temperature will also be shown) when you
switch it on.
However, if you place the weighing bowl
the kitchen scale
the kitchen scale will indicate the weight of the
weighing bowl
set the display to 0 g / 0.0 oz. The kitchen scale
now reads "TARE".
Place the weighing bowl
scale .
2
on Press the ON / OFF button
kitchen scale
. Press the battery
8
onto the battery com-
9
until it noticeably and audibly
and tighten
8
by using a screw driver.
2
.
8
by gently pulling the grip
or it may other-
10
and tighten
8
always starts at 0 g / 0.0
2
after you have switched it on,
2
. Press the Zero button
1
on the kitchen
1
to switch the
3
on.
2
out-
10
on
1
to re-
7
2
GB/CY 9