Result Of Measurement; Display Of Measurement Results; Print-Out Of Measurement Results - Bosch TTM 2104 Originalbetriebsanleitung

en | 40 | TTM 2104 / TTM 2204 | Measurement procedure
Front axle crosses diagnostic modules
 Quantity measurement system has detected the
crossing of a tire on both measuring units.
Rear axle crosses diagnostic modules
 Quantity measurement system has detected the
crossing of at least 3 tires.
"
The result of measurement is displayed some seconds
after the crossing.
|
1 691 206 005 2019-02-25
6.5

Result of measurement

6.5.1

Display of measurement results

The result of measurement is displayed some seconds
after the crossing.
i
The result display type can be preset in the Settings
menu (see chap. 8.3). The result display type can be
changed temporarily while the result is displayed:
R
Simple view.
R
Standard view.
R
Extended view.
i
After the result has been displayed, the next
crossing is possible. The view switches to the preset
result display type once the next crossing is started.
6.5.2

Print-out of measurement results

1. Select <Protocol>.
 Print view test protocol of the last crossing is dis-
played.
2. Set protocol view preferences.
R
Select right button to view the overall protocol
width.
R
Select left button to view the overall protocol height.
3. Select <Print> to print the protocol.
Robert Bosch GmbH