Installation Diagram Of Indoor Unit; Choosing The Unit Location - Carrier 42ADF025 Installationsanweisung

42ADF025, 42ADF035
Installation Diagram of the Indoor Unit
Batteries
TRS head wood screw
Do not allow the
drain hose to get
stack
Make sure to run the drain hose
sloped downward.

Choosing the Unit Location

Position to avoid:
• Exposed to direct sun.
• Too close to heat sources.
• A place with oil in the air.
• Where high frequency waves are generated by radio
equipment.
• On humid walls or positions with water hazard, e.g. laundry
premise.
• Where curtains or furniture may obstruct free air circulation.
Recommendations:
• Check that the wall surface is at enough to allow easy and
safe installation.
The wall structure should be strong enough to carry the unit
weight and avoid deformation, rupture or vibration during
operation.
• Consider using an area where installation is easy.
• Choose a position that allows for the clearances required (see
drawing).
2
Shield pipe
Wireless remote control
Remote control holder
Cut the piping
hole sloped
slightly.
Option lter
Direction of pipe
• The piping can be
connected to the four
directions indicated by
, , .
• When the piping is
connected to the direction
of , , or detach the
knockout.
• Look for a position in the room which assures the best
possible air distribution.
• Install unit in a position where condensate can easily be piped
to an appropriate drain.
Over Over
9 cm 20 cm
Over
10 cm
Hook
Installation
Hook
Air lter
,
Over
2 m
Obstacle Obstacle