Service; Safety Advice Relating Specifically To Delta Sanders; Have You Understood Everything; Preparing For Use - Parkside PDS 290 A1 Bedienungs- Und Sicherheitshinweise

General safety advice for electrical power tools / Preparing for use
f) Keep cutting tools clean and sharp.
Carefully maintained cutting tools with sharp
cutting edges are less likely to jam and are
easier to control.
g) Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and advice, and
the stipulations drawn up for this par-
ticular type of device. In doing this, take
into account the working conditions
and the task in hand. The use of electrical
power tools for purposes other than those in-
tended can lead to dangerous situations.

5. Service

a) Have your device repaired at the ser-
vice centre or by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
Safety advice relating spe-
cifically to delta sanders
S ecurely support the workpiece. Use clamps or
a vice to grip the workpiece firmly. This is much
safer than holding it in your hand.
N ever support yourself by placing your hands
near or in front of the device or the workpiece
surface. A slip can result in injury.
I f a dangerous situation arises, pull the mains
plug immediately out of the mains socket.
A lways work with the mains lead leading
away from the rear of the device.
D ANGER oF FIRE FRoM FLyING SPARKS!
Abrading metal creates flying sparks. For this
reason, always make sure that nobody is placed
in any danger and that there are no inflammable
materials near the working area.
Any harmful / noxious dusts generated from
sanding represent a risk to the health of the
person operating the device and to anyone
near the work area.
NoxIoUS FUMES!
Wear protective glasses and a
dust mask!
W hen sanding wood and in particular when work-
ing on materials that give rise to dusts that are
hazardous to health, the sander must be connect-
ed to a suitable external dust extraction device.
E nsure that there is adequate ventilation when
working on plastic, paint, varnish etc.
D o not soak the materials or the surface you
are about to work on with liquids containing
solvents.
D o not abrade moistened materials or damp
surfaces.
A void sanding paints containing lead or other
substances hazardous to health.
D o not work on materials containing asbestos.
Asbestos is a known carcinogen.
A void contact with the moving sanding sheet.
O perate the device only with an attached
sanding sheet.
N ever use the device for a purpose for which it
was not intended nor with non-original parts /
accessories. The use of tools or accessories other
than those recommended in the operating in-
structions could lead to you suffering an injury.
S witch the device off and allow it to come to a
standstill before you put it down.
A lways keep the device clean, dry and free of
oil or grease.
Have you understood
Q
everything?
O nce you have made yourself familiar with the
instructions and advice, the functioning and
handling of your device, you are finally in a
position to start work. Observing the manufac-
turer's instructions and advice will maximise
your safety while working with the device.

Preparing for use

Q
CAUTIoN! Make sure that the device is
switched off before you connect it to the mains
supply.
GB/MT 29