Concept KK1140 Bedienungsanleitung Seite 25

EN
OPERATING INSTRUCTIONS
The unit is only designed to treat human hair. Do not use it on wigs or animals.
1. Dry your hair with a towel after washing.
2. Brush your hair. Do not use hairspray, gel, or any other flammable substances.
3. Put a towel around your neck and on your shoulders, to prevent possible burning.
4. Uncoil the supply cable. Connect the power cord plug to the wall outlet.
5. After opening the straightener plates, release the lock (10). Turn the unit on by moving the switch (1) to the „1"
position. The control lamps 1-3 will light up immediately, control lamp 4 blinks (default temperature setting is 160
°C). After the appliance reaches the set temperature, the control lamp (4) will be lit continuously.
6. Set the required temperature using the -/+ (3) buttons for setting the temperature (Fig. 1). While the unit is still
reaching the set temperature, the relevant control lamp (4) is blinking. After the set temperature is reached, the
relevant control lamp (4) is lit continuously. The operating temperature is reached after approximately 1 minute.
Note: If you are using the unit for the first time, set the lowest temperature so that you prevent damaging your
hair.
Fig. 1
a) Straightening long hair
Always hold the unit by the grip (12) and at a sufficient distance from the skin
and eyes; use a mirror.
- Divide your hair into approximately 4 cm-wide strands.
- Hold the unit in your hand according to Fig. 2.
- Starting from the roots, put the prepared strand between the straightener
plates for a moment (see Fig. 2).
- Clamp the straightener plates (9) and pull them slowly from the roots to the
tips of the hair (see Fig. 2).
- Repeat until your hair is straight.
b) Straightening short hair
The process is the same as for long hair, but instead of pulling the unit along the hair, only press the strands between the
straightener plates for approximately 10 seconds.
c) Using the appliance for hair curling
Always hold the unit by the grip (12) and at a sufficient distance from the skin and eyes; use a mirror.
Divide your hair into approximately 3 to 5 cm-wide strands.
- Hold the appliance as shown in the Fig. 3. For easier manipulation, you can also use the other hand and hold the
appliance at the cold ends of the tongs (8). By pressing the lever (5) you open the curling tongs (7).
- Grip the prepared hair strand in the curling tongs and curl the hair from the tips into a curl (Fig. 4). The thinner the
strand, the firmer the curl that may be created.
KK1140
Fig. 2
23