Italiana Camini SIMPLI Installations-, Betriebs- Und Wartungsanleitung Seite 99

Start-up, fi rst switch on and testing must be carried out by an
authorised Edilkamin Technical Support Centre (TSC) in com-
pliance with standard UNI 10683.
This standard indicates the control operations to follow to
ensure the system is working properly.
The TSC will also calibrate the stove based on the type of
pellet and the installation conditions, thereby activating the
warranty.
If an authorised TSC does not carry out fi rst switch on the war-
ranty cannot be activated.
For information consult the website www.edilkamin.com
During fi rst switch on, faint odours of paint may develop which
will quickly disappear.
Before switching on, you must however check:
==> Correct installation
==> The electrical power supply.
==> Door closure, which must be sealed
==> Crucible cleaning.
==> The presence on the display of the stand-by indication
(date, power/temperature fl ashing).
LOADING PELLETS IN THE TANK
To access the tank, remove the metal cover
ATTENTION:
If you load the stove while it is on, it is therefore hot and the
specifi c glove supplied must be used.
Fig. 1
INSTRUCTIONS FOR USE
*
(Fig. 1).
*
- 99
NOTE on fuel.
SIMPLI was designed and programmed to burn wooden pel-
lets with an approx. diameter of 6 mm.
Pellets are fuel shaped like small cylinders, obtained by press-
ing sawdust, at high values, without
using glues or other foreign materials.
Pellets are sold in 15 Kg bags.
To AVOID compromising stove operation, do NOT burn
anything else.
Use of other materials (including wood), which can be de-
tected through laboratory analysis, would cause the warranty
to expire.
EDILKAMIN designed, tested and programmed its products
to guarantee the best performance using pellets with the fol-
lowing characteristics:
diameter: 6 millimetres
maximum length: 40 mm
maximum humidity: 8 %
heat yield: 4300 kcal/kg at least
The use of pellets with other characteristics would require
specifi c calibration of the stove, similar to that carried out by
the TSC (Technical Support Centre) on fi rst start-up.
The use of unsuitable pellets can cause: reduced performance;
functioning anomalies; blockages, dirt on glass, unburned
fuel, etc...
A simple analysis of the pellets can be visually carried out:
Good: smooth, regular length, little dust.
Poor quality: with longitudinal and transversal cracks, very
dusty, very variable length and the presence of
foreign bodies.
-