FUNCTIONING PRINCIPLE
The SIMPLI stove was designed to produce hot air using
wooden pellets as fuel, whose combustion is managed elec-
tronically.
Its functioning is illustrated below (the letters refer to Figure 1).
The fuel (pellets) is taken from the storage tank (A) and, using
an auger (B) activated by a gearmotor (C), is transported to the
combustion crucible (D).
The pellets are ignited using warm air produced by an electri-
cal resistance (E) and sucked into the crucible via the smoke
extractor (F).
The smoke produced by combustion is extracted from the fi re-
box using the same extractor (F), and expelled from the outlet
(G) with the possibility of joining on the rear, on the right/left
hand side and on top of the stove (see page 98).
The fi rebox, coated in Vermiculite, is closed on the front with a
small, ceramic glass door.
The quantity of combustible, fume extraction and fuel air feed
are adjusted by the electronic board equipped with software, to
obtain high yield and low emission combustion.
The stove is equipped with a serial socket for connection with
an optional cable (code 640560) to remote ignition devices
(such as telephone diallers, chronothermostats, etc.).
The outer, steel coating is available in two colour variations:
Bordeaux and parchment.
I
D
F
Fig. 1
A
B
E
C
G
- 93
SAFETY INFORMATION
The hot air is released into the installation environment through
a grill (I) located on the top front; the same environment is also
radiated by the small, glass door of the fi rebox.
• The appliance is not intended for use by people, including
children, whose physical, sensory or mental capacities are
reduced. Children must be supervised to ensure they don't play
with the appliance.
• The main risks due to stove use can relate to improper instal-
lation, direct contact with electrical, powered parts (interior),
contact with fi re and hot parts (glass, tubes, hot air outlet), the
introduction of foreign substances, fuel not recommended,
improper maintenance or repeated activation of the ignition key
without emptying the crucible.
• In the event of malfunctioning parts or anomalies, the stove
is equipped with safety devices to guarantee switch-off, which
you should allow to take place without intervention.
• To work properly, the stove must be installed in compliance
with the instructions on this data sheet.
• When the stove is on, the door to the fi rebox must not be
opened: combustion is in fact automatically managed and does
not require any intervention.
• Only use wooden pellets as fuel with a diameter of 6 mm, of
optimum quality and certifi ed.
• In no case should foreign substances, other than pellets, be
inserted in the fi rebox or the tank.
• Do not use fl ammable products to clean the smoke channel
(chimney section connecting the stove smoke outlet to the
chimney).
• The parts of the fi rebox and tank must only be vacuumed
COLD
• The glass can be cleaned COLD with specifi c product applied
with a cloth (e.g. Glasskamin by Edilkamin).
• Do not clean when hot.
• Ensure the stove is set in place and switched on by a TSC au-
thorised by Edilkamin (Technical Support Centre) according to
the instructions in this data sheet; these conditions are however
indispensable for warranty validation.
• When the stove is on, the discharge tubing and the door can
reach high temperatures (do not touch without the specifi c
glove).
• Do not places objects which are not resistant to heat in the
immediate vicinity of the stove.
• NEVER use liquid fuel to light the stove or re-light embers.
• Do not block ventilation openings in the installation premises,
nor air inlets to the stove itself.
• Do not wet the stove, do not approach the electrical parts with
wet hands.
• Do not insert tube reducers on the smoke vent.
• The stove must be installed in adequate premises to prevent
fi re and serviced with all utilities (feed and discharge) that the
appliance requires for correct and safe operation.
• As is necessary, clean the fl ue pass by removing the Vermicu-
lite fi rebox and removing the specifi c brackets.
• IF THE STOVE FAILS TO LIGHT, DO NOT REPEAT
IGNITION BEFORE EMPTYING THE CRUCIBLE (IT
COULD CAUSE DAMAGE).
• Attention: the pellets emptied from the crucible must not
be placed back in the tank.
-