B) Setup - Reely Stagger Bedienungsanleitung

b) Setup

• T he instructions for the remote control system and charger are included separately. Always follow all
the safety information as well as all other information! Numerous hazards are associated with improper
handling of the battery charger.
• Never wind the antenna cable! This significantly reduces the transmission range. Take care not to dam-
age the antenna cable. Never cut the antenna cable!
• Only use suitable drive rechargeable batteries for the vehicle. Never power the speed controller with a
power adapter, even for test purposes.
• T his vehicle is only suitable for one LiPo drive battery with 2 cells (rated voltage 7.4 V) or one NiMH drive
battery with 6-7 cells (rated voltage 7.2 V or 8.4 V).
When using a drive rechargeable battery with more cells, there is a danger of fire resulting from the
speed controller overheating. In addition, the vehicle's drive will be overloaded and thus damaged (e.g.
differential). This will void the warranty!
Caution!
The LiPo battery charger should only be used to charge a LiPo vehicle battery. Attempting to
charge a NiMH drive rechargeable battery with the LiPo battery charger may cause a fire or
explosion!
A LiPo drive rechargeable battery should only be charged with a suitable LiPo charger (and a NiMH
rechargeable battery with a NiMH charger only). So if you want to purchase a NiMH drive battery for the
vehicle, you will also need a suitable NiMH charger.
Always ensure that you use the correct type of battery charger.
• When putting the device into operation always turn on the remote control first. Only then can the drive
battery of the vehicle be connected to the speed controller and the speed controller be switched on.
Otherwise, the vehicle might react unpredictably.
Proceed as follows:
- Before connecting the battery, place the vehicle on a suitable surface so that all wheels can move
freely.
- Switch off the speed controller.
- Switch on the remote control, if you have not already done so. Check that it functions correctly (e.g.
transmitter's operating display).
- On the remote control, set the trim for the throttle/brake function to the central position.
- Connect a fully-charged drive battery to the speed controller in the correct polarity.
- Turn on the speed controller. Wait for a few seconds until the speed controller has completed a self-
test.
- Check that the vehicle reacts to the remote control commands as expected (steering and throttle)
before removing it from the support and placing the wheels on the ground.
39