Trouble-Shoting - FLAEM ProfiNeb P0915EM Bedienunganleitung

TROUBLE-SHOTING

Switch off the device before any procedure and unplug the power cable from the socket.
PROBLEM
The device does not work
The device does not
nebulize or nebulizes
insufficiently.
The apparatus is noisier
than usual
If after verifying the above mentioned conditions the device should not operate properly, contact your
trusted retailer or the nearest authorized FLAEM service center.
CAUSE
The power adaptor has not been
correctly inserted into the socket of
the device or the power socket
The medication has not been
inserted in the nebulizer
The nebulizer has not been prop-
erly fitted.
The nebulizer nozzle is clogged
The air pipe is not correctly con-
nected to the device
The air pipe is bent, damaged or
twisted
The air filter is dirty
The Filter is not correctly
inserted in its housing
17
SOLUTION
Correctly insert the power adaptor
in sockets.
Pour the right amount of medication
in the nebulizer
Disassemble the nebulizer and reas-
semble it correctly as shown in the
connection diagram on the cover
Disassemble the nebulizer, remove
the nozzle and perform cleaning
operations Failure to remove medi-
cation deposits from the nebulizer
affects its efficiency and operation.
Strictly comply with the instructions
contained in the CLEANING,
SANITISATION AND DISINFECTION
chapter
Ensure the device's accessories
are properly connected to the air
intake (see connection diagram on
the cover).
Unwind the pipe and ensure it is
not crushed or punctured. If neces-
sary replace it.
Replace the filter
Fully and properly insert the Filter
in its housing