FLAEM ProfiNeb P0915EM Bedienunganleitung Seite 15

For more effective inhalation therapy, position the valve speed selector (C1.4) pressing
on the opposite side of the word Max with your finger. In this case, you have optimal
assumption of the medication, minimising leaks into the surrounding environment, thanks
to the valvular system with which the nebuliser cup, mouthpiece and mask are equipped.
SOFTTOUCH MASKS
Soft
biocompatible
material
Dispersion
Limiting device
During inhalation, the tab that works
as a Dispersion Limiting device
bends toward the inside of the mask.
CLEANING, SANITISING, DISINFECTING
Switch off the device before any cleaning procedure and unplug the power cable from the socket.
DEVICE AND TUBING EXTERIOR
Use only a damp cloth with antibacterial soap (non-abrasive and with no solvents of any sort).
ACCESSORIES
Open the nebuliser by turning the upper part (C1.3) anticlockwise, remove the nozzle (C1.2) from the upper
part (C1.3) as shown in the "Assembly diagram" in point C1.
Then proceed according to the following instructions.
SANITISATION
Before and after each use, sanitise the nebuliser cup and the accessories, choosing one of the methods
described below.
method A: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4 under potable hot water (approximately
40°C) with a gentle, non abrasive dish detergent.
method B: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4 in the dishwasher with a hot cycle.
method C: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4 by immersing them in a solution of 50% water
and 50% white vinegar, then rinse thoroughly under potable hot water (approximately 40°C).
If you also wish to perform cleaning by DISINFECTION, jump to the DISINFECTION paragraph.
The SoftTouch masks have an external edge made in soft, biocompat-
ible material that guarantees optimal adherence to the face and are
also equipped with the innovative Dispersion Limiting device. These
distinctive features allow increased sedimentation of the medication
within the patient's body, also limiting its dispersion.
13
During exhalation, the tab that works as a
Dispersion Limiting device bends toward
the outside of the mask.