Troubleshooting - SCOPREGA BRAVO TURBO MAX KIT 12V Bedienungsanleitung

WARNING: Do not leave the unit running unattended. Over-inflation of items could result in serious injury.
WARNING: RISK OF BURSTING! Excessive air pressure may cause a hazardous risk of bursting or
personal injury. Check the manufacturer's maximum pressure rating for items being inflated.
WARNING: Check that the inflatable valve is open. Close valve may result in item damage or breakage
• Manually open the valve of your inflatable boat or structure
• remove the valve's cap, push and turn the inner valve's pin
(or only push it – depending on the specific valve) to set the valve in open configuration
• In alternative, make sure of using a correct valve adapter from the universal 7-nozzle-kit
supplied. A proper adapter has to firmly suit the valve and keep the valve open during the
deflation. Adapters with inner cross-bar are most recommended for electric pumps
• Set the Pressure Knob to the desired limit. WHEN DEFLATING SET TO 175 mbar.
• Press the Main Switch to ON
• Press the Start Switch to START
• When the boat/structure is deflated to your desired point, press the OFF Switch to STOP.
WARNING: Do not leave the unit running unattended. Over-deflation of items could result in vacuum
effect and seriously damage the inflator

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
12/24 Volt cord not properly
Unit will not Start
connected
Power supply not live
Main ON/OFF switch not ON
The Safety Fuse is blown
Cord or switches are damaged
Will not inflate/deflate
Wrong Port connected
Wrong setting on
the Pressure knob
Main ON/OFF switch not ON
ACCESSORIES
Recommended accessories for use with your inflator are available from your local dealer or authorized
service center.
WARNING: THE USE OF ANY ACCESSORY NOT RECOMMENDED FOR USE WITH THIS INFLATOR COULD
BE HAZARDOUS
POSSIBLE SOLUTION
Connect the Power Supply. Make sure polarity is correct
(Red to Positive; Black to Negative pole)
Check the connectors
Turn main switch to ON
Replace the fuse with one of the same size (40 or 70 A)
Have switch replaced by BRAVO Service Center
Connect the air hose to the proper Port
(IN to deflate; OUT to inflate)
Adjust settings
Turn main switch to ON and then press START
Instruction Manual
WARNING: READ THIS MANUAL BEFORE OPERATING THE PRODUCT
ELEKTRISCHE
AUFLASSVORRICHTUNG 12/24 VDC
Katalognummer
BRAVO TURBO MAX KIT 12V 6130021
BRAVO TURBO MAX KIT 24V 6130036
BRAVO TURBO MAX KIT 24V-S 6130071
DIESE ANLEITUNG AUFBEWAHREN
HINWEIS: LESEN SIE DIESE ANLEITUNG BEVOR SIE DAS GERÄT VERWENDEN
BRAVO TURBO MAX 12V 6130022
BRAVO TURBO MAX 24V 6130023
BRAVO TURBO MAX 24V-S 6130072
Bedienungsanleitung