Parkside Performance PABSP 20-Li B2 Bedienungs- Und Sicherheitshinweise Seite 18

2 gear:
nd
Suitable for:
Speed:
Torque:
˜ Setting the rotating direction
m
ATTENTION! RISK OF PRODUCT
DAMAGE!
Do not operate the rotation direction
switch 5 until the product has come to
a standstill .
Change the direction of rotation by pressing
¾
the rotation direction switch 5 towards the
left or right (fig . G) .
When the rotation direction switch 5 is in
¾
the middle position, the on/off switch 6 is
locked .
˜ Torque control
This product is equipped with a torque control that
disengages the spindle when a predefined torque
is exceeded .
The torque can be adjusted by turning the
¾
torque sleeve 3 (fig . H) .
Small screws or soft materials: Select a low
¾
level .
Large screws, hard materials or removing
¾
screws: Select a high level .
For drilling operation: Turn the torque sleeve
¾
3 to the position .
˜ Switching on and off
NOTE
The on/off switch 6 cannot be locked .
Drilling
High
Low
Switching on: Press and hold the on/off
¾
switch 6 .
Regulate the speed as required (see "Speed
control") (fig . I) .
Switching off: Release the on/off switch
¾
6 .
˜ Speed control
By using the on/off switch 6 , you can
¾
progressively control the speed:
Pressure
Gentle pressure:
Greater pressure:
˜ LED work light
This product is equipped with a LED work light
11 to illuminate the immediate working area to
improve visibility in poorly lit areas .
The LED work light 11 lights up automatically
¾
as soon as the product is switched on .
NOTE
The LED work light 11 stays on for an
u
additional approx . 10 seconds after
switching off the product .
˜ Trial run
NOTE
Always carry out a no-load trial run before
u
starting work and after every accessory
tool replacement . Switch the product off
immediately if the accessory tool is not
running smoothly, if considerable vibration
occurs or if you hear abnormal noises .
Speed
Lower speed
Higher speed
GB 17