Assembling - Woom Off Bedienungsanleitung

6�2 Assembling
See Section 11.1 on page 56 for tightening torques.
Mounting the handlebar
4 mm
Unscrew the clamps from the stem.

ATTENTION
The brake cables and the shift cable must be to the left of the head tube.
Turn the handlebar 90° clockwise and insert into
the stem.
41
4 mm
Screw on the clamps, tighten The cross mark must be in
the screws only slightly. the middle between the two
clamps.

HINT
Make sure that the gap between clamps and stem is the same at the top and bottom!
Adjust the tilt of the handlebar.
Default setting: 0°. Tighten the
clamps.
42