mastro 65/70 BRE Bedienungsanleitung Seite 17

2.3 WATER CONNECTION
To carry out a correct installation the following must be respected:
1) The water feed pipes must be connected to the mains using cut off cocks which should
always be closed when the tilting pan is not being used or during maintenance
interventions.
2) A mechanical filter must be installed between the cut off cock and the pipes feeding the
tilting pan in order to avoid the build up of ferrous materials that when rusting could
damage the stainless steel and lead to the presence of rust spots on the tank . You are
therefore advised to drain off a small amount of water before attaching the last length of
piping to the tilting pan so washing away any eventual ferrous materials.
3) If rust points do form on the tank this will be due to the build up of ferrous materials or the
stagnant of iron filings. The stainless steel is not the cause.
4) The 1/2" water inlet can be found on the lower right-hand side of the tilting pan. The water
load pipe is marked with the symbol....
NOTE: the manufacturer takes no responsibility and has no guarantee obligations for
damage caused by not respecting the laws and standards in force or for a non
professional installation.
3. SWITCHING ON
1) Tilting pans are cooking appliances and must be used exclusively by professionally
qualified personnel following these instructions; Any other use is to be considered
improper and therefore dangerous.
2) Before cooking for the first time clean the inside of the pan carefully using hot water and
detergent and then rinse well.
3) Switch the appliance on following the user instructions and allow it to work unloaded for
about 15 minutes.
3.1 USER INSTRUCTIONS – SWITCHING ON AND SWITCHING OFF
ATTENTION! The appliance must only be used under the operator's surveillance!!!
Switch on the main switch. Turn the tilting pan knob from "0" to the desired temperature
between 50° C and 300° C. Both of the indicator light s will light up. The green light indicates
that the appliance is receiving power and the yellow light indicates that the heating elements
are working, until they reach the set temperature. To switch off the appliance, turn the knob to
the "0" position and switch off the power at the mains.
H O
2
USER INSTRUCTIONS