Vitek VT-4214 R Betriebsanweisung Seite 5

• Attention! Do not allow children to play with poly-
ethylene bags or packaging film. Danger of suf-
focation!
• This unit is not intended for usage by children or
disabled persons unless they are given all the nec-
essary and understandable instructions by a person
who is responsible for their safety on safety mea-
sures and information about danger that can be
caused by improper usage of the unit.
• Do not use the unit outdoors.
• To avoid damages, transport the unit in original
package only.
• Never pull the power cord, when disconnecting the
unit from the mains, take the power plug and care-
fully pull it out of the socket.
• Never use the unit if the power cord or the power
plug is damaged, if the unit works improperly or af-
ter it was dropped. Do not try to repair the unit by
yourself. Contact an authorized service center for
all repair issues.
• Keep the unit away from children in a dry cool place.
THE UNIT IS INTENDED FOR HOUSEHOLD USAGE ONLY
USING OF THE COOKING BOWL (12)
• Use the multicooker and its removable parts for the
intended purposes only.
• Do not place the bowl (12) on heating units or cook-
ing surfaces.
• Do not use other containers for cooking instead of
the bowl (12).
• Always make sure that the heating element (9) sur-
face and the bottom of the bowl (12) are clean and
dry.
• To avoid damage of the non-stick coating never
chop hard products in the bowl (12).
• Never leave or keep any foreign objects in the bowl
(12).
• When cooking food in the bowl (12) stir it only with
the spatula (21) or soup ladle (22). You can also use
wooden, plastic or silicone kitchen accessories.
• Do not stir the products in the bowl (12) with metal
objects which can scratch the non-stick coating.
• After cooking dishes with spices and seasonings
wash the bowl (12) right after cooking.
• Do not put the bowl (12) into cold water right after
cooking; let it cool down first. This helps to avoid
damaging the non-stick coating.
• The bowl (12) is not intended for washing in the
dishwashing machine.
BEFORE THE FIRST USE
In case of unit transportation or storage at low tem-
perature it is necessary to keep it for at least two
hours at room temperature before switching on.
– Unpack the unit, remove any stickers and package
materials that can prevent multicooker operation.
– Place the multicooker on the flat, heat-resistant
surface away from all kitchen heat sources (gas
cooker, electric cooker or cooking unit).
– Place the multicooker keeping at least 20 cm gap
between the multicooker body and the wall and 30-
40 cm gap above the unit.
– Do not place the multicooker close to the objects
that can be damaged by the released steam of high
temperature.
Attention! Do not use the unit near bath tubs,
kitchen sinks or other containers filled with water.
– Open the lid (5) by pressing the button (1) and re-
move the bowl (12).
– Remove the protection screen (11) by pressing the
clamps (14) on the bottom part of the screen.
– Press the steam valve (6) from the inner side of the
lid and take it out, then dissemble it by turning its
lower part to the position
– Wash all removable parts: steam valve (6), protec-
tion screen (11), the bowl (12), the spatula (21), the
soup ladle (22), the measuring cup (23), the steam
cooking basket (24), cups (25) and lids (26). Then
rinse them under running water.
– Before making yogurt disinfect the cups (25) and
the lids (26) by scalding them.
– Dry all the removable parts thoroughly.
– Clean the unit body with a damp cloth then wipe
it dry.
– Assemble the steam valve (6) by turning the bottom
part clockwise till locking (position
– Install protection screen (11) back to its place: in-
sert the upper part of the protection screen (11) into
the grooves on the lid (5), fix the bottom part till the
clamps clicking.
Current time setting
– Insert the power cord jack into the connector (8)
and the power cord plug into the socket, you'll hear
a sound signal.
– Press and hold the button (20) «TIME» for about 3
seconds, there will be a short sound signal, release
the button (20) «TIME» and digital «hours» value will
be flashing.
– Consequently pressing or holding the button (13)
«+» or (14) «-», set current time in «hours» (24 Hr).
– Press the button (20) «TIME» again, then use the
button (13) «+»or (14) «-» to set «minutes» value.
– To finish the setup procedure press the button (17)
«START».
– The current time will appear on the display (4) and
the divisional dots «:» will be flashing.
Note: If you didn't perform any actions during 5 sec-
onds or didn't confirm time setting by pressing the
button (17) «START», the current time will not be shown.
CONTROL PANEL BUTTONS (3)
«MENU» Button (15)
To select a cooking program, press the button (15)
«MENU» consequently, an arrow will appear opposite
the selected program. The default duration of the se-
lected program will be shown on display (4).
5
ENGLISH
.
).