CHIEF iCLPFA2 Installationsanleitung Seite 9

Installation Instructions
3
x4
5
x4
5
INSTALL FACEPLATE TO DISPLAY
VESA Compliant Display
IMPORTANT ! :
200X200mm, then proceed to "INSTALL BRACKETS TO DISPLAY."
Otherwise, continue below.
NOTE:
100X100mm mounting pattern shown; 75x75mm, 100x200mm, and
200x200mm mounting patterns similar.
1. Lay display face down on protective surface.
E
CAUTION:
Proper screws will easily thread into display mounting holes.
2. Select screw diameter by examining hardware bags "A" through "D" (8mm,
6mm, 5mm, or 4mm) and comparing with mounting holes on display.
3. Select spacers:
• If mounting holes are not recessed, and faceplate (E) can lay flat
1
against display, then no spacers are required.
• If mounting holes are recessed, or if protrusions prevent faceplate (E)
from laying flat, then spacers (GA or GB) must be used. Select shortest
spacer which will provide adequate fill. All spacers must be same
length.
CAUTION:
Proper screws will have adequate thread engagement without contacting
bottom of display mounting holes.
4. Select screw length:
• Using your hand, insert SHORTEST length screw of selected diameter
(AA, BA, CA, or DA) through faceplate (E), selected spacer (GA or GB,
if required), into display mounting hole. Do NOT thread screw into hole
at this time.
• Proper screw length requires base of screw head to protrude above
faceplate (E) a distance equal to or greater than the screw diameter. If
screw length is inadequate, insert longer screw. Select shortest screw
which will protrude the required distance.
E
CAUTION:
5. Carefully install selected screws. Ensure the following:
• Threaded stud is towards bottom of display, and
• All applicable display mounting holes (4 or 6) are used.
GA x4, GB x4
6. Proceed to "INSTALL DISPLAY TO ARM ASSEMBLY."
1
If your display has a mounting pattern larger than
Using screws of improper diameter may damage your display!
Using screws of improper length may damage your display!
Do not overtighten screws!
iCLPFA2
9