User Interface - Eliwell Coldface EWRC300LX Bedienungsanleitung

KEYS
No. KEY
Battery p UP
B ESC
c SETPOINT
Q q DOWN
E ENERGY SAVING
F ON/OFF
G LIGHT
H AUX

USER INTERFACE

How to modify the SetPoint
• Press and release the SET key. The upper display will show SEt, the lower display will indicate the
current SetPoint value
• Press and release the SET key once more. The upper display will show SEt blinking
• Use the UP & DOWN keys to adjust the SetPoint value
• Press the ESC key several times (or keep it pressed) to return to the normal display
How to read the probe values
• Press and release the SET key. The upper display will show SEt, the lower display will indicate the
current SetPoint value
• Press and release the DOWN key. If the RTC clock is present, the time will be shown in the lower display
• Press and release the DOWN key once more. The upper display will show Pb1, the lower display
will indicate the value read by the room probe
• Press and release the DOWN key once more to read the value of probe Pb2 and Pb3 if configured
• Press the ESC key to return to the normal display
How to modify the Lite Parameters
The Lite parameters are the most useful parameters and are described in this document, in
the section Parameters Table.
1) Press and hold the SET key for 3 seconds until the display shows PAr / Lite
2) Press and release the SET key once more. The upper display will show the first parameter*, the
lower display will indicate the current parameter value
3) Using the UP & DOWN keys, find the parameter that you wish to modify
4) Press and release the SET key once more. The upper display will show the name of the blinking
parameter
5) Use the UP & DOWN to adjust the parameter value
6) Press and release SET to save the parameter value
7) Return to step 3) or press ESC several times to return to the normal display
5 - EN
press and release
•Alarms Menu (always visible)
• Scroll
• Increase values
• Exit
• Functions menu
• Display SetPoint / probe values / time*
• Confirm values
• Access value edit mode
(upper display blinking)
• Scroll
• Decrease values
• Display instrument INFO**
/
/
/
/
press and hold for about 3 seconds
/
• Manual defrost
• Return to Main Menu
Access Parameter Edit mode
/
Activate energy saving
Switch device On/Off
Switch light on/off
Activate auxiliary function
Notes
HACCP alarms
only in HACCP models and when
alarms present
* Models with clock
Configurable - see parameter H32
**See Technical Support
press and hold until
Activate Night & Day
EWRC300/500LX