Hardware Reset - Simons Voss Technologies WaveNet LockNode Kurzanleitung

7. Hardware reset

Signal test
LED
flashes one to two times
flashes three to four times
flashes five to six times
7. Hardware reset
You can reset WaveNet Manager-enabled LockNodes (re-
cognisable by WNM in the article number):
1. Disconnect the LockNode from the power supply or re-
move the batteries.
2. Wait for about 20 seconds.
3. Press and hold the Init button.
4. Reconnect the power supply or replace the batteries.
LED lights up constantly red.
9
5. Release the Init button while the LED is constantly red.
All WaveNet information in the LockNode is deleted.
9
You can re-integrate the LockNode into your WaveNet (see
WaveNet manual).
Signal quality
poor
OK
Optimum
30 / 116 | EN