Installation - Simons Voss Technologies WaveNet LockNode Kurzanleitung

5. Installation

sensor
The signal LED indicates the operating status, the Init button
can reset WNM-LockNodes (see
or test the signal quality of WN-LockNodes (see ).
5. Installation
1. Unpack the LockNode.
2. Check if the LockNode is damaged.
3. Place the LockNode at a maximum distance of 30 cm
I/O panel
(WN.LN.SENSOR.CABLE)
green (In-Common)

pink (input 1, connection

with green = 1, otherwise
0)
grey (input 2, connection

with green = 1, otherwise
0)
yellow (input 3,

connection with green =
1, otherwise 0)
brown (open collector

output)
white (ground)

Hardware reset [} 30]
28 / 116 | EN
)