Connecting The Water Hose To Demijohn - Beko GNE134751X Handbuch

Installation
A
WARNING:
is enabled before removing the by-pass
cover.
C
It is normal that a few drops of water drip
after the cover has been removed.
4. Seat the water filter cover into the mechanism and
push forwards to lock it in place.
5. Press "Ice Off" button on the display again to
exit this mode.
C
Water filter must be replaced every 6
months. When replacing the water filter
or if you will not use the filter anymore,
remove it as illustrated in the figure and
install the bypass cover. Make sure that the
"Ice Off" mode is enabled before removing
the filter.
A
WARNING:
foreign particles in the water. It does not
purify water from microorganisms.
A
WARNING: Ice Off
pressed before replacing the water filter or
installing the by-pass cover.
A
WARNING:
replacement of the filter.
Ensure that the Ice Off mode
Water filter cleans some
button must be
Unplug the product during the
3.11 Connecting the water
hose to demijohn
(in some models)
To make the water supply connection between
the refrigerator and the demijohn, you must use
a water pump. Follow the instructions below after
connecting one end of the water hose coming out
of the pump to the refrigerator.
1. Complete the connection by pushing the other
end of the water hose into the water hose inlet
of the pump.
2. Put and fix the pump hose into the demijohn.
3. After completing the connection, plug in and run
the pump.
C
After the pump starts to operate, wait for
2-3 minutes to allow it attain the required
efficiency.
C
You can refer to the user manual of the
pump while making the water connection.
C
There is no need to use water filter if you
will be using a demijohn.
12 / 32 EN
Refrigerator / User Manual