Care And Maintenance; Utilization; Warranty - CONDTROL HYDRO PRO Bedienungsanleitung

WOOD AND CONCRETE
EN
MOISTURE METER

CARE AND MAINTENANCE

Attention! This device is a precision instrument and requires careful handling.
Maintenance of the following recommendations will extend the life of the
device:
- Protect the device from bumps, falling and intense vibration; do not allow
moisture, dust and foreign objects get inside the device.
- If liquids get inside the device, first remove the batteries, then contact a service
center.
- As soon as operation is finished, remove the particles of material, dirt, tar, etc.
from the sensor.
- Do not store and use the device in increased humidity conditions.
- Do not store the product in rooms where temperature is below -10°С. After
storage in low temperature conditions and subsequent transfer to a warm room,
the device heats up, causing moisture condense inside the device and damage
microcircuits.
- Do not expose the device to direct sunlight and protect it from prolonged
exposure to sunlight and high temperature.
- Clean the device with a soft cloth slightly made damp with a mild soap solution.
Do not use cleaning solvents or abrasives.
Failure to observe the following rules may lead to electrolyte leakage from the
batteries and damage the device:
- Remove the batteries from the device if you don't use it for a long time.
- Do not use batteries of different types, with different charge level.
- Do not leave discharged batteries in the device.

UTILIZATION

Expired tools, accessories and package should be passed for waste recycle. Please
send the product to the following address for proper recycle:
CONDTROL GmbH
Wasserburger Strasse 9
84427 Sankt Wolfgang
Germany
Do not throw the product in municipal waste!
According to European directive 2002/96/ЕC expired measuring tools and their
components must be collected separately and submitted to environmentally
friendly recycle of wastes.
14
HYDRO PRO CONDTROL
User manual
WOOD AND CONCRETE
EN
MOISTURE METER

WARRANTY

All CONDTROL GmbH products go through post-production control and are
governed by the following warranty terms. The buyer's right to claim about defects
and general provisions of the current legislation do not expire.
1) CONDTROL GmbH agrees to eliminate all defects in the product, discovered
while warranty period, that represent the defect in material or workmanship in
full volume and at its own expense.
2) The warranty period is 24 months and starts from the date of purchase by the
end customer (see the original supporting document).
3) The warranty doesn't cover defects resulting from wear and tear or improper
use, malfunction of the product caused by failure to observe the instructions of
this user manual, untimely maintenance and service and insufficient care, the use
of non-original accessories and spare parts. Modifications in design of the product
relieve the seller from responsibility for warranty works. The warranty does not
cover cosmetic damage, that doesn't hinder normal operation of the product.
4) CONDTROL GmbH reserves the right to decide on replacement or repair of the
device.
5) Other claims not mentioned above, are not covered by the warranty.
6) After holding warranty works by CONDTROL GmbH warranty period is not
renewed or extended.
7) CONDTROL GmbH is not liable for loss of profit or inconvenience associated
with a defect of the device, rental cost of alternative equipment for the period of
repair.
This warranty applies to German law except provision of the United Nations
Convention on contracts for the international sale of goods (CISG).
In warranty case please return the product to retail seller or send it with
description of defect to the following address:
CONDTROL GmbH
Wasserburger Strasse 9
84427 Sankt Wolfgang
Germany
HYDRO PRO CONDTROL
User manual
15